logo

CuriousTab

CuriousTab

Discussion


Home Electronics Resistance and Power Comments

  • Question
  • For P = V2/R, a decrease in resistance should produce:


  • Options
  • A. a decrease in power
  • B. an increase in ohms
  • C. an increase in power
  • D. a decrease in current

  • Correct Answer
  • an increase in power 


  • Resistance and Power problems


    Search Results


    • 1. What type of resistors have a tolerance rating of 5% or greater?

    • Options
    • A. precision
    • B. SIP
    • C. general-purpose
    • D. wirewound
    • Discuss
    • 2. A conductor's cross-sectional area in circular mils for inch is:

    • Options
    • A. 500 cmils
    • B. 100,000 cmils
    • C. 1,000,000 cmils
    • D. 500,000,000 cmils
    • Discuss
    • 3. Resistor tolerance is either printed on the component, or is provided by:

    • Options
    • A. keyed containers
    • B. size
    • C. color code
    • D. ohmmeter reading
    • Discuss
    • 4. If a variable resistor's resistance varies in a nonuniform manner as the shaft is moved, it is considered to be:

    • Options
    • A. linear
    • B. defective
    • C. not wirewound
    • D. tapered
    • Discuss
    • 5. With 1 mA of current, what wattage rating should a 470 ohm resistor have?

    • Options
    • A. 1/4 watt
    • B. 1/2 watt
    • C. 1 watt
    • D. 2 watts
    • Discuss
    • 6. One advantage of a carbon film resistor over a carbon composition resistor is:

    • Options
    • A. less circuit noise
    • B. smaller size
    • C. higher wattage
    • D. poor tolerance
    • Discuss
    • 7. Which formula shows a direct proportionality between power and voltage?

    • Options
    • A. V = IR
    • B. P = VI
    • C. P = IR
    • D. I = V/R
    • Discuss
    • 8. A potentiometer has how many leads?

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 4
    • Discuss
    • 9. If a calculator display was "0.00263," what would this answer be in percent?

    • Options
    • A. 0.026%
    • B. 0.26%
    • C. 2.63%
    • D. 26.3%
    • Discuss
    • 10. A 33 kΩ resistor with a 20% tolerance checks out as ok with which of the following ohmmeter readings?

    • Options
    • A. 26400 ohms
    • B. 24183 ohms
    • C. 6600 ohms
    • D. 39970 ohms
    • Discuss


    Comments

    There are no comments.

Enter a new Comment