logo

CuriousTab

CuriousTab

Discussion


Home Electronics Resistance and Power Comments

  • Question
  • Which type of test equipment is used to measure resistors?


  • Options
  • A. ohmmeter
  • B. ammeter
  • C. voltmeter
  • D. watt meter

  • Correct Answer
  • ohmmeter 


  • Resistance and Power problems


    Search Results


    • 1. The source is 24 volts and the load resistance is 100 Ω. What is the load current?

    • Options
    • A. 2.4 A
    • B. 240 mA
    • C. 24 mA
    • D. 2.4 mA
    • Discuss
    • 2. Power is measured in units of:

    • Options
    • A. joules x charge
    • B. joules/work
    • C. joules x voltage
    • D. joules/time
    • Discuss
    • 3. Resistance in a circuit is:

    • Options
    • A. opposition to current
    • B. opposition to voltage
    • C. the same as current
    • D. the same as voltage
    • Discuss
    • 4. What value of a 1.3 kΩ resistor as measured by a digital voltmeter would be considered within tolerance?

    • Options
    • A. 1234 Ω
    • B. 1235 Ω
    • C. 1366 Ω
    • D. 1367 Ω
    • Discuss
    • 5. Resistance is:

    • Options
    • A. the opposition to current flow accompanied by the dissipation of heat
    • B. symbolized by R, measured in ohms, and directly proportional to conductance
    • C. directly proportional to current and voltage
    • D. represented by the flow of fluid in the fluid circuit
    • Discuss
    • 6. How is a 3.9 kΩ resistor color-coded?

    • Options
    • A. red, white, red, gold
    • B. red, green, orange, silver
    • C. orange, white, red, gold
    • D. orange, green, orange, silver
    • Discuss
    • 7. How much energy is stored if 6.24 x 1018 electrons are stored in 4 volts?

    • Options
    • A. 4 joules
    • B. 1.56 x 1018 electrons
    • C. 1.56 coulombs
    • D. 2.496 x 1019 electrons
    • Discuss
    • 8. The unit designator for resistance value is the:

    • Options
    • A. ampere
    • B. ohm
    • C. volt
    • D. watt
    • Discuss
    • 9. Which is the most important step utilized when measuring resistors?

    • Options
    • A. use the highest possible scale
    • B. keep test leads short
    • C. zero the meter before using
    • D. remove power from the circuit
    • Discuss
    • 10. If a metallic conductor has a positive temperature coefficient of resistance, then:

    • Options
    • A. as temperature increases, resistance decreases
    • B. as current increases, resistance decreases
    • C. as voltage increases, current increases
    • D. as temperature increases, resistance increases
    • Discuss


    Comments

    There are no comments.

Enter a new Comment