logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Special-Purpose Op-Amp Circuits Comments
  • Question

  • When using an OTA in a Schmitt-trigger configuration, the trigger points are controlled by


  • Options
  • A. the Iout
  • B. the IBIAS
  • C. the Vout
  • D. both Iout and IBIAS

  • Correct Answer
  • both Iout and IBIAS 

    • Special-Purpose Op-Amp Circuits problems

    Search Results

    • 1. 

      This circuit is a setup for


    • Options
    • A. an antilog amplifier
    • B. a constant-current source
    • C. an instrumentation amplifier
    • D. an isolation amplifier
      • Discuss
    • 2. 

      Refer the given circuits. Which circuit is known as an OTA?


    • Options
    • A. a
    • B. b
    • C. c
    • D. d
      • Discuss
    • 3. The primary function of the oscillator in an isolation amplifier is to

    • Options
    • A. convert dc to high-frequency ac
    • B. convert dc to low-frequency ac
    • C. rectify high-frequency ac to dc
    • D. produce dual-polarity dc voltages for the input to the demodulator
      • Discuss
    • 4. An instrumentation amplifier has a high

    • Options
    • A. output impedance
    • B. power gain
    • C. CMRR
    • D. supply voltage
      • Discuss
    • 5. Circuits that shift the dc level of a signal are called

    • Options
    • A. limiters
    • B. clampers
    • C. peak detectors
    • D. dc converters
      • Discuss
    • 6. 

      Which circuit is known as a voltage-to-current converter?


    • Options
    • A. a
    • B. b
    • C. c
    • D. d
      • Discuss
    • 7. 

      This circuit is a setup for


    • Options
    • A. an antilog amplifier
    • B. a constant-current source
    • C. an instrumentation amplifier
    • D. an isolation amplifier
      • Discuss
    • 8. How do fixed resistors usually fail?

    • Options
    • A. slowly over time
    • B. by increasing their value
    • C. by becoming an open circuit
    • D. by increasing their value and becoming an open circuit
      • Discuss
    • 9. What resistor type is found in SIPs and DIPs?

    • Options
    • A. metal film
    • B. wirewound
    • C. metal oxide
    • D. thick film
      • Discuss
    • 10. Resistors are identified as to wattage by:

    • Options
    • A. size
    • B. color code
    • C. types of materials
    • D. internal construction
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.