logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Transistors and Applications Comments
  • Question

  • The depletion-mode MOSFET


  • Options
  • A. can operate with only positive gate voltages
  • B. can operate with only negative gate voltages
  • C. cannot operate in the ohmic region
  • D. can operate with positive as well as negative gate voltages

  • Correct Answer
  • can operate with positive as well as negative gate voltages 

    • Transistors and Applications problems

    Search Results

    • 1. The capacitor that produces an ac ground is called a(n)

    • Options
    • A. coupling capacitor
    • B. dc open
    • C. bypass capacitor
    • D. ac open
      • Discuss
    • 2. In order for feedback oscillators to have any practical value, the gain has to be

    • Options
    • A. < 1
    • B. self-adjusting
    • C. stabilized
    • D. nonlinear
      • Discuss
    • 3. Three different points are shown on a dc load line. The upper point represents the

    • Options
    • A. minimum current gain
    • B. quiescent point
    • C. saturation point
    • D. cutoff point
      • Discuss
    • 4. A source follower has a voltage gain (Av) of

    • Options
    • A. AV = gmRd
    • B. AV = gmRS
    • C.
    • D.
      • Discuss
    • 5. To get a negative gate-source voltage in a self-biased JFET circuit, you must use a

    • Options
    • A. voltage divider
    • B. source resistor
    • C. ground
    • D. negative gate supply voltage
      • Discuss
    • 6. In a class B push-pull amplifier, the transistors are biased slightly above cutoff to avoid

    • Options
    • A. crossover distortion
    • B. unusually high efficiency
    • C. negative feedback
    • D. a low input impedance
      • Discuss
    • 7. The primary function of the bias circuit is to

    • Options
    • A. hold the circuit stable at VCC
    • B. hold the circuit stable at vin
    • C. ensure proper gain is achieved
    • D. hold the circuit stable at the designed Q-point
      • Discuss
    • 8. The formula used to calculate the approximate ac resistance of the base-emitter diode (re) is

    • Options
    • A.
    • B. re ≈ 25 mV × IC
    • C.
    • D.
      • Discuss
    • 9. Which of the following conditions are needed to properly bias an npn transistor amplifier?

    • Options
    • A. Forward bias the base/emitter junction and reverse bias the base/collector junction.
    • B. Forward bias the collector/base junction and reverse bias the emitter/base junction.
    • C. Apply a positive voltage on the n-type material and a negative voltage on the p-type material.
    • D. Apply a large voltage on the base.
      • Discuss
    • 10. The signal voltage gain of an amplifier, Av, is defined as:

    • Options
    • A.
    • B. Av = IC × RC
    • C.
    • D.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.