logo

CuriousTab

CuriousTab

Discussion


Home Electronics RC Circuits Comments

  • Question
  • Which statement about a series RC circuit is true?


  • Options
  • A. The capacitor's voltage drop is in phase with the resistor's voltage drop.
  • B. The current leads the source voltage.
  • C. The current lags the source voltage.
  • D. The resistor voltage lags the current.

  • Correct Answer
  • The current leads the source voltage. 


  • RC Circuits problems


    Search Results


    • 1. 

      What is the current through XC1 in the given circuit?


    • Options
    • A. 32.2 mA
    • B. 16 mA
    • C. 12 mA
    • D. 48 mA
    • Discuss
    • 2. Power that is measured in volt-amperes is called

    • Options
    • A. impedance power
    • B. reactive power
    • C. true power
    • D. apparent power
    • Discuss
    • 3. 

      If the frequency increases in the given circuit, how would the total current change?


    • Options
    • A. The total current would increase.
    • B. The total current would decrease.
    • C. The total current would remain the same.
    • D. More information is needed in order to predict how the total current would change.
    • Discuss
    • 4. 

      Calculate the magnitude of the impedance in the given circuit.


    • Options
    • A. 24.1 MΩ
    • B. 10 MΩ
    • C. 26.1 MΩ
    • D. 0 Ω
    • Discuss
    • 5. In a 20 Vac series RC circuit, if 20 V is read across the resistor and 40 V is measured across the capacitor, the applied voltage is

    • Options
    • A. 45 Vac
    • B. 50 Vac
    • C. 60 Vac
    • D. 65 Vac
    • Discuss
    • 6. 

      What is the current through the load in the given circuit?


    • Options
    • A. 500 µA
    • B. 10 mA
    • C. 250 mA
    • D. 1.25 A
    • Discuss
    • 7. A transformer has

    • Options
    • A. primary and secondary windings, both of which are considered inputs
    • B. primary and secondary windings, both of which are considered outputs
    • C. a primary winding used as an output and a secondary winding used as an input
    • D. a primary winding used as an input and a secondary winding used as an output
    • Discuss
    • 8. Increasing the number of turns of wire on the secondary of a transformer will

    • Options
    • A. increase the secondary current
    • B. decrease the secondary current
    • C. have no effect on the secondary current
    • D. increase the primary current
    • Discuss
    • 9. The coefficient of coupling between two coils is 0.45. The first coil has an inductance of 75 mH and the second coil has an inductance of 105 mH. What is the mutual inductance between the coils?

    • Options
    • A. 3.54 mH
    • B. 7.88 mH
    • C. 39.9 mH
    • D. 189.3 mH
    • Discuss
    • 10. What is the turns ratio of the transformer needed to match a 1 kΩ source resistance to a 160 Ω load?

    • Options
    • A. 2.5:1
    • B. 0.4:1
    • C. 6.25:1
    • D. 16:1
    • Discuss


    Comments

    There are no comments.

Enter a new Comment