Discussion
Home ‣ Electronics ‣ Diodes and Applications Comments
- Question
An IC regulator receives an overload; it will:
Options- A. shut down
- B. compensate for heat
- C. provide more voltage
- D. sample and adjust
- Correct Answer
- shut down
- 1. Testing a good diode with an ohmmeter should indicate
Options- A. high resistance when forward or reverse biased
- B. low resistance when forward or reverse biased
- C. high resistance when reverse biased and low resistance when forward biased
- D. high resistance when forward biased and low resistance when reverse biased Discuss
- 2. The characteristic curve for the complex model of a silicon diode shows that
Options- A. the barrier potential is 0 V
- B. the barrier potential stays fixed at 0.7 V
- C. the barrier potential increases slightly with an increase in current
- D. the barrier potential decreases slightly with an increase in current Discuss
- 3. When matching polarity connections have been made and the potential difference (PD) is above 0.7 V, the diode is considered to be:
Options- A. not working
- B. forward biased
- C. reverse biased
- D. an open switch Discuss
- 4. The voltage where current may start to flow in a reverse-biased pn junction is called the
Options- A. breakdown voltage
- B. barrier potential
- C. forward voltage
- D. biasing voltage Discuss
- 5. What is a varistor?
Options- A. a voltage-dependent resistor
- B. a voltage-dependent diode
- C. a current-dependent resistor
- D. a current-dependent diode Discuss
- 6. When a diode is destroyed it has infinite impedance. When damaged by heat it will probably:
Options- A. short
- B. conduct more
- C. conduct less
- D. open Discuss
- 7. The area at the junction of p-type and n-type materials that has lost its majority carriers is called the
Options- A. barrier potential
- B. depletion region
- C. n region
- D. p region Discuss
- 8. With a half-wave rectified voltage across the load resistor, load current flows for what part of a cycle?
Options- A. 0 degrees
- B. 90 degrees
- C. 180 degrees
- D. 360 degrees Discuss
- 9. Shunting the ac component away from the load is the task of a:
Options- A. transformer
- B. filter
- C. regulator
- D. rectifier Discuss
- 10. If the frequency of the applied ac signal to a half-wave rectifier is 60 Hz, the frequency of the pulsating dc output will be
Options- A. 30 pps
- B. 60 pps
- C. 90 pps
- D. 120 pps Discuss
Diodes and Applications problems
Search Results
Correct Answer: high resistance when reverse biased and low resistance when forward biased
Correct Answer: the barrier potential increases slightly with an increase in current
Correct Answer: forward biased
Correct Answer: breakdown voltage
Correct Answer: a voltage-dependent resistor
Correct Answer: short
Correct Answer: depletion region
Correct Answer: 180 degrees
Correct Answer: filter
Correct Answer: 60 pps
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.