logo

CuriousTab

CuriousTab

Discussion


Home Electronics Inductors Comments

  • Question
  • Which two values are plotted on a B-H curve graph?


  • Options
  • A. reluctance and flux density
  • B. permeability and reluctance
  • C. magnetizing force and permeability
  • D. flux density and magnetizing force

  • Correct Answer
  • flux density and magnetizing force 


  • Inductors problems


    Search Results


    • 1. Find IR and IL.


    • Options
    • A. IR = 50 mA, IL = 109 mA
    • B. IR = 150 mA, IL = 9 mA
    • C. IR = 50 mA, IL = 151 mA
    • D. IR = 150 mA, IL = 53 mA
    • Discuss
    • 2. What happens when moving expanding lines of force encounter a conductor?

    • Options
    • A. Current increases.
    • B. Voltage is induced.
    • C. Resistance is reduced.
    • D. Power is increased.
    • Discuss
    • 3. If 360 Vac is the output of a 300-turn secondary winding, what is the input voltage when the primary winding has 150 turns?

    • Options
    • A. 2.4 Vac
    • B. 150 Vac
    • C. 180 Vac
    • D. 720 Vac
    • Discuss
    • 4. A magnetic field has:

    • Options
    • A. polar fields
    • B. lines of force
    • C. magnetomotive force
    • D. lines of reluctance
    • Discuss
    • 5. When a rate of one ampere per second causes an induced voltage of one volt, the unit of measure is

    • Options
    • A. a lenz
    • B. an ohm
    • C. a farad
    • D. a henry
    • Discuss
    • 6. A utility pole transformer used to supply a residential customer with two phases uses:

    • Options
    • A. two phases on the primary
    • B. a center tap on the secondary
    • C. a separate ground for each phase
    • D. a small coefficient of coupling
    • Discuss
    • 7. A winding of wire can be called

    • Options
    • A. an inductor
    • B. a coil
    • C. a choke
    • D. All of the above
    • Discuss
    • 8. Counter emf or induced voltage is:

    • Options
    • A. inversely proportional to the change in current
    • B. directly proportional to the change in time
    • C. directly proportional to the inductance in henrys
    • D. inversely proportional to the inductance in henrys
    • Discuss
    • 9. What is the phase angle between the source voltage and current, when a 100 mH inductor with a reactance of 6 kΩ, and a 1 kΩ resistor are in series with a source?

    • Options
    • A. 0.1 degrees
    • B. 9.0 degrees
    • C. 61.0 degrees
    • D. 81.0 degrees
    • Discuss
    • 10. In a purely inductive circuit,

    • Options
    • A. current leads voltage by 90°
    • B. voltage lags current by 90°
    • C. voltage leads current by 90°
    • D. voltage and current are in phase (0°)
    • Discuss


    Comments

    There are no comments.

Enter a new Comment