logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Inductors Comments
  • Question

  • A magnetic field has:


  • Options
  • A. polar fields
  • B. lines of force
  • C. magnetomotive force
  • D. lines of reluctance

  • Correct Answer
  • lines of force 

    • Inductors problems

    Search Results

    • 1. When a rate of one ampere per second causes an induced voltage of one volt, the unit of measure is

    • Options
    • A. a lenz
    • B. an ohm
    • C. a farad
    • D. a henry
      • Discuss
    • 2. What is the total inductance, assuming no mutual inductance?


    • Options
    • A. 12 mH
    • B. 6 mH
    • C. 0.73 mH
    • D. 0 mH
      • Discuss
    • 3. What is magnetic flux?

    • Options
    • A. the number of lines of force in webers
    • B. the number of lines of force in maxwells
    • C. the number of lines of force in teslas
    • D. the number of lines of force in flux density
      • Discuss
    • 4. Which of the following represents a true equivalent of an inductor?

    • Options
    • A. An inductance in series with a resistance and a capacitance
    • B. A capacitance in parallel with the series combination of a resistance and an inductance
    • C. An inductance in parallel with the series combination of a resistance and a capacitance
    • D. The only quality a real inductor has is inductance.
      • Discuss
    • 5. A series RL filter circuit with an output across the inductor will result in what type of filtering?

    • Options
    • A. passing of the higher frequencies
    • B. passing of the lower frequencies
    • C. blocking of the higher frequencies
    • D. blocking of a certain range of frequencies
      • Discuss
    • 6. If 360 Vac is the output of a 300-turn secondary winding, what is the input voltage when the primary winding has 150 turns?

    • Options
    • A. 2.4 Vac
    • B. 150 Vac
    • C. 180 Vac
    • D. 720 Vac
      • Discuss
    • 7. What happens when moving expanding lines of force encounter a conductor?

    • Options
    • A. Current increases.
    • B. Voltage is induced.
    • C. Resistance is reduced.
    • D. Power is increased.
      • Discuss
    • 8. Find IR and IL.


    • Options
    • A. IR = 50 mA, IL = 109 mA
    • B. IR = 150 mA, IL = 9 mA
    • C. IR = 50 mA, IL = 151 mA
    • D. IR = 150 mA, IL = 53 mA
      • Discuss
    • 9. Which two values are plotted on a B-H curve graph?

    • Options
    • A. reluctance and flux density
    • B. permeability and reluctance
    • C. magnetizing force and permeability
    • D. flux density and magnetizing force
      • Discuss
    • 10. A utility pole transformer used to supply a residential customer with two phases uses:

    • Options
    • A. two phases on the primary
    • B. a center tap on the secondary
    • C. a separate ground for each phase
    • D. a small coefficient of coupling
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.