CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Electronics
‣
Inductors
Comments
Question
Fixed transformers have:
Options
A. a center-tapped secondary
B. multiple windings
C. turns ratios that cannot be changed
D. a multiple-tapped secondary
Correct Answer
turns ratios that cannot be changed
Inductors problems
Search Results
1. If a Wheatstone bridge is balanced, a voltmeter in the center of the bridge will read:
Options
A. the same as the source voltage
B. half the source voltage
C. zero volts
D. twice the source voltage
Show Answer
Scratch Pad
Discuss
Correct Answer: zero volts
2. What is the total resistance of a circuit when R
1
(7 k Ω) is in series with a parallel combination of R
2
(20 k Ω), R
3
(36 k Ω), and R
4
(45 k Ω)?
Options
A. 4 k Ω
B. 17 k Ω
C. 41 k Ω
D. 108 k Ω
Show Answer
Scratch Pad
Discuss
Correct Answer: 17 k Ω
3. If a series?parallel circuit has all 30-ohm resistors, what is the total resistance when R
1
is in series with a parallel circuit consisting of R
2
and R
3
?
Options
A. 10 ohms
B. 20 ohms
C. 45 ohms
D. 90 ohms
Show Answer
Scratch Pad
Discuss
Correct Answer: 45 ohms
4.
If the load in the given circuit is open, what is the unloaded output voltage?
Options
A. 0 V
B. 4 V
C. 16 V
D. 20 V
Show Answer
Scratch Pad
Discuss
Correct Answer: 16 V
5. What is the voltage to the load?
Options
A. 11.4 V
B. 12.4 V
C. 13.4 V
D. 15.4 V
Show Answer
Scratch Pad
Discuss
Correct Answer: 15.4 V
6. Electricity may be generated by a wire:
Options
A. carrying current
B. wrapped as a coil
C. that has neutral domains
D. passing through a flux field
Show Answer
Scratch Pad
Discuss
Correct Answer: passing through a flux field
7. What is the permeability of machine steel?
Options
A. 1.1 x 10
?4
B. 5.65 x 10
?4
C. 6.9 x 10
?3
D. 8.8 x 10
?3
Show Answer
Scratch Pad
Discuss
Correct Answer: 5.65 x 10
?4
8. What is the approximate time for a complete decay of 400 mA of inductor current, when R = 10 ohms and L = 20 H?
Options
A. 10 seconds
B. 8 seconds
C. 4 seconds
D. 2 seconds
Show Answer
Scratch Pad
Discuss
Correct Answer: 10 seconds
9. Electromagnetic induction is the generation of:
Options
A. electricity from magnetism
B. electricity from electricity
C. magnetism from electricity
D. magnetism from magnetism
Show Answer
Scratch Pad
Discuss
Correct Answer: electricity from magnetism
10. Current will cause a magnetic field in a conductor as follows:
Options
A. An ac current causes a fixed polarity magnetic field.
B. A dc current causes a fixed polarity magnetic field.
C. A dc current causes an alternating magnetic field.
D. An ac current causes a fixed polarity magnetic field and a dc current causes an alternating magnetic field.
Show Answer
Scratch Pad
Discuss
Correct Answer: A dc current causes a fixed polarity magnetic field.
Comments
There are no comments.
Enter a new Comment
Save
More in Electronics:
Alternating Current and Voltage
Alternating Current vs Direct Current
Analog and Digital Converters
Analog to Digital
Arithmetic Operations and Circuits
Basic Op-Amp Circuits
Bipolar Junction Transistors (BJT)
Capacitors
Combinational Logic Circuits
Computer Hardware and Software
Diodes and Applications
Field Effect Transistors (FET)
Flip-Flops and Timers
Inductors
Logic Circuit Simplification
Logic Gates
Magnetism and Electromagnetism
Measurement, Conversion and Control
Number Systems and Codes
Ohm's Law
Operational Amplifiers
Parallel Circuits
Programmable Logic Devices (PLD)
Quantities and Units
RC Circuits
Resistance and Power
RL Circuits
RLC Circuits and Resonance
Semiconductor Memory
Semiconductor Principles
Sequential Logic Circuits
Series-Parallel Circuits
Series Circuits
Special-Purpose Op-Amp Circuits
Standard Logic Devices (SLD)
Testing and Troubleshooting
Thyristors and Tranducers
Time Response of Reactive Circuits
Transformers
Transistors and Applications
Voltage and Current