When placed into a circuit, how are electronic components usually connected? pos

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics ‣ Series-Parallel Circuits Comments

Question
When placed into a circuit, how are electronic components usually connected?
Options
A. positive terminal to positive terminal
B. in parallel
C. as a combination of series and parallel
D. in series

Correct Answer

as a combination of series and parallel

Series-Parallel Circuits problems

Search Results

1.

Which circuit fault do the meter readings in the given figure indicate?
Options
A. The 1 kΩ resistor is shorted.
B. The 4.7 kΩ resistor is shorted.
C. The 2.2 kΩ resistor is shorted.
D. The 3.3 kΩ resistor is shorted.

6. In a series?parallel circuit, individual component power dissipations are calculated using:
Options
A. individual component parameters
B. a percent of the voltage division ratio squared
C. total current squared multiplied by the resistor values
D. a percent of the total power depending on resistor ratios

8. What is the power dissipated by R1, R2, and R3?
Options
A. P1 = 0.13 W, P2 = 0.26 W, P3 = 0.12 W
B. P1 = 0.26 W, P2 = 0.52 W, P3 = 0.23 W
C. P1 = 0.52 W, P2 = 0.92 W, P3 = 0.46 W
D. P1 = 1.04 W, P2 = 1.84 W, P3 = 0.92 W

9.

In the given circuit, what is R_UNK equal to if R_V must be adjusted to 1,232 Ω in order to balance the bridge?
Options
A. 220 Ω
B. 6,899 Ω
C. 1,232 Ω
D. More information is needed in order to find R_UNK.

Comments

More in Electronics: