logo

CuriousTab

CuriousTab

Discussion


Home Electronics Series-Parallel Circuits Comments

  • Question
  • Which circuit fault do the meter readings in the given figure indicate? The 1 k? resistor is shorted

    Which circuit fault do the meter readings in the given figure indicate?


  • Options
  • A. The 1 kΩ resistor is shorted.
  • B. The 4.7 kΩ resistor is shorted.
  • C. The 2.2 kΩ resistor is shorted.
  • D. The 3.3 kΩ resistor is shorted.

  • Correct Answer
  • The 3.3 kΩ resistor is shorted. 


  • Series-Parallel Circuits problems


    Search Results


    • 1. What is the total resistance?


    • Options
    • A. 800 Ω
    • B. 1.2 kΩ
    • C. 1.6 kΩ
    • D. 1.8 kΩ
    • Discuss
    • 2. 

      How much current is flowing through R1 in the given circuit?


    • Options
    • A. 0.3 A
    • B. 0.15 A
    • C. 0.5 A
    • D. 0.68 A
    • Discuss
    • 3. What is the total resistance?


    • Options
    • A. 2.2 kΩ
    • B. 3.2 kΩ
    • C. 4.2 kΩ
    • D. 5.2 kΩ
    • Discuss
    • 4. What determines if resistor connections are in series, parallel, or series?parallel?

    • Options
    • A. the voltage source
    • B. the power source
    • C. resistance
    • D. current flow
    • Discuss
    • 5. When a Wheatstone bridge is in a balanced condition, the center voltmeter in the bridge will read:

    • Options
    • A. twice the source voltage
    • B. the same as the source voltage
    • C. zero volts
    • D. half the source voltage
    • Discuss
    • 6. When placed into a circuit, how are electronic components usually connected?

    • Options
    • A. positive terminal to positive terminal
    • B. in parallel
    • C. as a combination of series and parallel
    • D. in series
    • Discuss
    • 7. In a series?parallel circuit, individual component power dissipations are calculated using:

    • Options
    • A. individual component parameters
    • B. a percent of the voltage division ratio squared
    • C. total current squared multiplied by the resistor values
    • D. a percent of the total power depending on resistor ratios
    • Discuss
    • 8. 

      What is the total resistance of the given circuit?


    • Options
    • A. 92 Ω
    • B. 288 Ω
    • C. 17.7 Ω
    • D. 128 Ω
    • Discuss
    • 9. What is the power dissipated by R1, R2, and R3?


    • Options
    • A. P1 = 0.13 W, P2 = 0.26 W, P3 = 0.12 W
    • B. P1 = 0.26 W, P2 = 0.52 W, P3 = 0.23 W
    • C. P1 = 0.52 W, P2 = 0.92 W, P3 = 0.46 W
    • D. P1 = 1.04 W, P2 = 1.84 W, P3 = 0.92 W
    • Discuss
    • 10. 

      In the given circuit, what is RUNK equal to if RV must be adjusted to 1,232 Ω in order to balance the bridge?


    • Options
    • A. 220 Ω
    • B. 6,899 Ω
    • C. 1,232 Ω
    • D. More information is needed in order to find RUNK.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment