logo

CuriousTab

CuriousTab

Discussion


Home Electronics Bipolar Junction Transistors (BJT) See What Others Are Saying!
  • Question
  • A collector characteristic curve is a graph showing:


  • Options
  • A. emitter current (IE) versus collector-emitter voltage (VCE) with (VBB) base bias voltage held constant
  • B. collector current (IC) versus collector-emitter voltage (VCE) with (VBB) base bias voltage held constant
  • C. collector current (IC) versus collector-emitter voltage (VC) with (VBB) base bias voltage held constant
  • D. collector current (IC) versus collector-emitter voltage (VCC) with (VBB) base bias voltage held constant

  • Correct Answer
  • collector current (IC) versus collector-emitter voltage (VCE) with (VBB) base bias voltage held constant 


  • More questions

    • 1. 

      The output voltage is _____ at the resonant frequency in the given circuit.


    • Options
    • A. 0 mV
    • B. 31.4 mV
    • C. 66.5 mV
    • D. 380 mV
    • Discuss
    • 2. The control bus and memories share a bidirectional bus in a typical microprocessor system.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. 

      Which circuit fault do the meter readings in the given figure indicate?


    • Options
    • A. The 1 kΩ resistor is shorted.
    • B. The 4.7 kΩ resistor is shorted.
    • C. The 2.2 kΩ resistor is shorted.
    • D. The 3.3 kΩ resistor is shorted.
    • Discuss
    • 4. Germanium is the most widely used semiconductor material because of its stability at high temperatures.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. What do variable capacitors use for dielectric?

    • Options
    • A. ceramic, electrolytic, mica, or paper
    • B. air, ceramic, mica, or plastic
    • C. ceramic, paper, plastic, or mica
    • D. mica, ceramic, plastic, or electrolytic
    • Discuss
    • 6. During a current change, the ability of a conductor to produce counter emf within itself is called:

    • Options
    • A. back emf
    • B. self-induction
    • C. a henry
    • D. impedance
    • Discuss
    • 7. Holding current for an SCR is best described as

    • Options
    • A. the minimum current required for turn-off
    • B. the current required before an SCR will turn on
    • C. the amount of current required to maintain conduction
    • D. the gate current required to maintain conduction
    • Discuss
    • 8. Power is measured in units of:

    • Options
    • A. joules x charge
    • B. joules/work
    • C. joules x voltage
    • D. joules/time
    • Discuss
    • 9. Adding in binary, the decimal values 26 + 27 will produce a sum of:

    • Options
    • A. 111010
    • B. 110110
    • C. 110101
    • D. 101011
    • Discuss
    • 10. Pulse-triggered flip-flops are also called _________ flip-flops.

    • Options
    • A. master-slave
    • B. postponed
    • C. level
    • D. edge
    • Discuss


    Comments

    Avatar
    arowtaita
    After 3 times washing by TBS for 10 min each, sections were mounted to glass slides

    Avatar
    GHdFmwiG
    We also performed sensitivity analyses to examine the impact on the results in relation to a number of factors including comedication, quality of allocation concealment, blinding, intention- to- treat analysis, source of funding, and different diagnostic criteria of PCOS or obesity 26

    Avatar
    generic priligy online
    This puts the implantation bleeding window just a day or so before a woman would otherwise expect her period


Enter a new Comment