logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Bipolar Junction Transistors (BJT) Comments
  • Question

  • Three different Q points are shown on a dc load line. The upper Q point represents the:


  • Options
  • A. minimum current gain
  • B. intermediate current gain
  • C. maximum current gain
  • D. cutoff point

  • Correct Answer
  • maximum current gain 

    • Bipolar Junction Transistors (BJT) problems

    Search Results

    • 1. With the positive probe on an NPN base, an ohmmeter reading between the other transistor terminals should be:

    • Options
    • A. open
    • B. infinite
    • C. low resistance
    • D. high resistance
      • Discuss
    • 2. The input/output relationship of the common-collector and common-base amplifiers is:

    • Options
    • A. 270 degrees
    • B. 180 degrees
    • C. 90 degrees
    • D. 0 degrees
      • Discuss
    • 3. Total emitter current is:

    • Options
    • A. IE ? IC
    • B. IC + IE
    • C. IB + IC
    • D. IB ? IC
      • Discuss
    • 4. When transistors are used in digital circuits they usually operate in the:

    • Options
    • A. active region
    • B. breakdown region
    • C. saturation and cutoff regions
    • D. linear region
      • Discuss
    • 5. Which is beta's current ratio?

    • Options
    • A. IC/IB
    • B. IC/IE
    • C. IB/IE
    • D. IE/IB
      • Discuss
    • 6. A current ratio of IC/IE is usually less than one and is called:

    • Options
    • A. beta
    • B. theta
    • C. alpha
    • D. omega
      • Discuss
    • 7. Most of the electrons in the base of an NPN transistor flow:

    • Options
    • A. out of the base lead
    • B. into the collector
    • C. into the emitter
    • D. into the base supply
      • Discuss
    • 8. The symbol hfe is the same as:

    • Options
    • A.
    • B.
    • C. hi-fi
    • D.
      • Discuss
    • 9. The C-B configuration is used to provide which type of gain?

    • Options
    • A. voltage
    • B. current
    • C. resistance
    • D. power
      • Discuss
    • 10. A transistor may be used as a switching device or as a:

    • Options
    • A. fixed resistor
    • B. tuning device
    • C. rectifier
    • D. variable resistor
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.