logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Bipolar Junction Transistors (BJT) Comments
  • Question

  • Often a common-collector will be the last stage before the load; the main function(s) of this stage is to:


  • Options
  • A. provide voltage gain
  • B. provide phase inversion
  • C. provide a high-frequency path to improve the frequency response
  • D. buffer the voltage amplifiers from the low-resistance load and provide impedance matching for maximum power transfer

  • Correct Answer
  • buffer the voltage amplifiers from the low-resistance load and provide impedance matching for maximum power transfer 

    • Bipolar Junction Transistors (BJT) problems

    Search Results

    • 1. What is the current gain for a common-base configuration where IE = 4.2 mA and IC = 4.0 mA?

    • Options
    • A. 16.80
    • B. 1.05
    • C. 0.20
    • D. 0.95
      • Discuss
    • 2. The ends of a load line drawn on a family of curves determine:

    • Options
    • A. saturation and cutoff
    • B. the operating point
    • C. the power curve
    • D. the amplification factor
      • Discuss
    • 3. When a silicon diode is forward biased, what is VBE for a C-E configuration?

    • Options
    • A. voltage-divider bias
    • B. 0.4 V
    • C. 0.7 V
    • D. emitter voltage
      • Discuss
    • 4. A transistor has a of 250 and a base current, IB, of 20 µ A. The collector current, IC, equals:

    • Options
    • A. 500 µ A
    • B. 5 mA
    • C. 50 mA
    • D. 5 A
      • Discuss
    • 5. Voltage-divider bias provides:

    • Options
    • A. an unstable Q point
    • B. a stable Q point
    • C. a Q point that easily varies with changes in the transistor's current gain
    • D. a Q point that is stable and easily varies with changes in the transistor's current gain
      • Discuss
    • 6. If a 2 mV signal produces a 2 V output, what is the voltage gain?

    • Options
    • A. 0.001
    • B. 0.004
    • C. 100
    • D. 1000
      • Discuss
    • 7. In a transistor, collector current is controlled by:

    • Options
    • A. collector voltage
    • B. base current
    • C. collector resistance
    • D. all of the above
      • Discuss
    • 8. In a C-E configuration, an emitter resistor is used for:

    • Options
    • A. stabilization
    • B. ac signal bypass
    • C. collector bias
    • D. higher gain
      • Discuss
    • 9. Which is beta's current ratio?

    • Options
    • A. IC/IB
    • B. IC/IE
    • C. IB/IE
    • D. IE/IB
      • Discuss
    • 10. When transistors are used in digital circuits they usually operate in the:

    • Options
    • A. active region
    • B. breakdown region
    • C. saturation and cutoff regions
    • D. linear region
      • Discuss

    Comments

    Avatar
    zeduccale
    The surgeon instructed the patient to stop breast feeding and return to his office in 2 4 weeks, at which time a mammogram would be obtained and a biopsy would be performed if the mass was still present
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.