Discussion
Home ‣ Electronics ‣ Alternating Current vs Direct Current Comments
- Question
What is the rms voltage value of an ac signal whose peak oscilloscope display uses 3 major divisions above the zero setting? (V/cm = 5)
Options- A. 5.3 V
- B. 10.6 V
- C. 15.0 V
- D. 21.2 V
- Correct Answer
- 10.6 V
- 1. Test equipment selection enables the technician to both generate signals and:
Options- A. change circuit conditions
- B. inject signals
- C. sense circuit conditions
- D. change signal frequencies Discuss
- 2. The phase difference between sine waves of different frequencies is:
Options- A. equal to their frequency differences
- B. the difference in their fixed time displacement
- C. the same throughout time
- D. constantly changing Discuss
- 3. What are the two main applications for ac?
Options- A. direct, pulsating
- B. electric, magnetic
- C. power, information
- D. static, dynamic Discuss
- 4. The current is flowing in what direction?
Options- A. clockwise
- B. counterclockwise
- C. in both directions at the same time
- D. 50% of the time clockwise and 50% of the time counterclockwise Discuss
- 5. What is the waveform period difference between the 60 Hz electricity used in this country and the 50 Hz used in Europe?
Options- A. 3 ms
- B. 16 ms
- C. 4 ms
- D. 20 ms Discuss
- 6. Signal comparisons may be most easily seen when using which item of test equipment?
Options- A. spectrum analyzer
- B. multimeter
- C. function generator
- D. dual trace oscilloscope Discuss
- 7. If current varies periodically from zero to a maximum, back to zero, and then repeats, the signal is:
Options- A. direct
- B. alternating
- C. pulsating
- D. repetitive Discuss
- 8. Power companies supply ac, not dc, because:
Options- A. it is easier to transmit ac
- B. there is no longer a need for dc
- C. dc is more dangerous
- D. there are not enough batteries Discuss
- 9. If a sine wave signal is 100 mV peak-to-peak, how many volts would be measured by a voltmeter?
Options- A. 14.14 mV
- B. 35.4 mV
- C. 63.7 mV
- D. 70.7 mV Discuss
- 10. One oscilloscope selector knob that allows the major and minor divisions of the graticule to be used to determine a signal amplitude value is called the:
Options- A. time/cm control
- B. position control
- C. intensity control
- D. volts/cm control Discuss
Alternating Current vs Direct Current problems
Search Results
Correct Answer: sense circuit conditions
Correct Answer: the difference in their fixed time displacement
Correct Answer: power, information
Correct Answer: 50% of the time clockwise and 50% of the time counterclockwise
Correct Answer: 3 ms
Correct Answer: dual trace oscilloscope
Correct Answer: pulsating
Correct Answer: it is easier to transmit ac
Correct Answer: 35.4 mV
Correct Answer: volts/cm control
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.