Discussion
Home ‣ Electronics ‣ Measurement, Conversion and Control Comments
- Question
RTDs are typically connected with other fixed resistors
Options- A. in a pi configuration
- B. in a bridge configuration
- C. and variable resistors
- D. and capacitors in a filter-type circuit
- Correct Answer
- in a bridge configuration
- 1. What is the zero-voltage switch used for?
Options- A. To reduce radiation of high frequencies during turn-on of a high current to a load
- B. To control low-voltage circuits
- C. To provide power to a circuit when power is lost
- D. For extremely low-voltage applications Discuss
- 2. Which of the following performance specifications applies to a sample-and-hold circuit?
Options- A. Aperture time
- B. Aperture droop
- C. Feedback
- D. Acquisition jitter Discuss
- 3. What device is similar to an RTD but has a negative temperature coefficient?
Options- A. Strain gauge
- B. Thermistor
- C. Negative-type RTD
- D. Thermocouple Discuss
- 4. Holding current for an SCR is best described as
Options- A. the minimum current required for turn-off
- B. the current required before an SCR will turn on
- C. the amount of current required to maintain conduction
- D. the gate current required to maintain conduction Discuss
- 5. What is the moving part of a linear variable differential transformer?
Options- A. Primary
- B. Secondary
- C. Diaphragm
- D. Core Discuss
- 6. The silicon-controlled rectifier can be turned off
Options- A. by a negative gate pulse
- B. by forced commutation
- C. with the off switch
- D. when the breakover voltage is exceeded Discuss
- 7. The output voltage of a typical thermocouple is
Options- A. less than 100 mV
- B. greater than 1 V
- C. Thermocouples vary resistance, not voltage.
- D. None of the above Discuss
- 8. The connections to a thermocouple
Options- A. can produce an unwanted thermocouple effect, which must be compensated for
- B. produce an extra desirable thermocouple effect
- C. must be protected, since high voltages are present
- D. produce an extra desirable thermocouple effect and must be protected, since high voltages are present Discuss
- 9. Temperature sensing can be achieved by the use of
Options- A. thermocouples
- B. RTDs
- C. thermistors
- D. All of the above Discuss
- 10. A sine wave has:
Options- A. four quadrants
- B. two alternations
- C. one period
- D. all of the above Discuss
Measurement, Conversion and Control problems
Search Results
Correct Answer: To reduce radiation of high frequencies during turn-on of a high current to a load
Correct Answer: Aperture time
Correct Answer: Thermistor
Correct Answer: the amount of current required to maintain conduction
Correct Answer: Core
Correct Answer: by forced commutation
Correct Answer: less than 100 mV
Correct Answer: can produce an unwanted thermocouple effect, which must be compensated for
Correct Answer: All of the above
Correct Answer: all of the above
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.