Discussion
Home ‣ Electronics ‣ Measurement, Conversion and Control Comments
- Question
Holding current for an SCR is best described as
Options- A. the minimum current required for turn-off
- B. the current required before an SCR will turn on
- C. the amount of current required to maintain conduction
- D. the gate current required to maintain conduction
- Correct Answer
- the amount of current required to maintain conduction
- 1. What is the moving part of a linear variable differential transformer?
Options- A. Primary
- B. Secondary
- C. Diaphragm
- D. Core Discuss
- 2. The purpose of compensation for a thermocouple is
Options- A. to decrease temperature sensitivity
- B. to increase voltage output
- C. to cancel unwanted voltage output of a thermocouple
- D. used for high-temperature circuits Discuss
- 3. The change in value of an analog signal during the conversion process produces what is called the
Options- A. quantization error
- B. resolution error
- C. Nyquist error
- D. sampling error Discuss
- 4. The resistive change of a strain gauge
Options- A. is based on the weight placed upon it, but can be many thousands of ohms
- B. is usually no more than 100 Ω
- C. is based on the gauge factor, but is typically less than an ohm
- D. has a positive temperature coefficient Discuss
- 5. A basic series regulator has
Options- A. an error detector
- B. a load
- C. a reference voltage
- D. both an error detector and a reference voltage Discuss
- 6. What device is similar to an RTD but has a negative temperature coefficient?
Options- A. Strain gauge
- B. Thermistor
- C. Negative-type RTD
- D. Thermocouple Discuss
- 7. Which of the following performance specifications applies to a sample-and-hold circuit?
Options- A. Aperture time
- B. Aperture droop
- C. Feedback
- D. Acquisition jitter Discuss
- 8. What is the zero-voltage switch used for?
Options- A. To reduce radiation of high frequencies during turn-on of a high current to a load
- B. To control low-voltage circuits
- C. To provide power to a circuit when power is lost
- D. For extremely low-voltage applications Discuss
- 9. RTDs are typically connected with other fixed resistors
Options- A. in a pi configuration
- B. in a bridge configuration
- C. and variable resistors
- D. and capacitors in a filter-type circuit Discuss
- 10. The silicon-controlled rectifier can be turned off
Options- A. by a negative gate pulse
- B. by forced commutation
- C. with the off switch
- D. when the breakover voltage is exceeded Discuss
Measurement, Conversion and Control problems
Search Results
Correct Answer: Core
Correct Answer: to cancel unwanted voltage output of a thermocouple
Correct Answer: quantization error
Correct Answer: is based on the gauge factor, but is typically less than an ohm
Correct Answer: both an error detector and a reference voltage
Correct Answer: Thermistor
Correct Answer: Aperture time
Correct Answer: To reduce radiation of high frequencies during turn-on of a high current to a load
Correct Answer: in a bridge configuration
Correct Answer: by forced commutation
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.