Discussion
Home ‣ Electronics ‣ Measurement, Conversion and Control Comments
- Question
The purpose of compensation for a thermocouple is
Options- A. to decrease temperature sensitivity
- B. to increase voltage output
- C. to cancel unwanted voltage output of a thermocouple
- D. used for high-temperature circuits
- Correct Answer
- to cancel unwanted voltage output of a thermocouple
- 1. The change in value of an analog signal during the conversion process produces what is called the
Options- A. quantization error
- B. resolution error
- C. Nyquist error
- D. sampling error Discuss
- 2. The resistive change of a strain gauge
Options- A. is based on the weight placed upon it, but can be many thousands of ohms
- B. is usually no more than 100 Ω
- C. is based on the gauge factor, but is typically less than an ohm
- D. has a positive temperature coefficient Discuss
- 3. A basic series regulator has
Options- A. an error detector
- B. a load
- C. a reference voltage
- D. both an error detector and a reference voltage Discuss
- 4. In an averaging amplifier, the input resistances are
Options- A. equal to the feedback resistance
- B. less than the feedback resistance
- C. greater than the feedback resistance
- D. unequal Discuss
- 5. The ramp voltage at the output of an op-amp integrator
Options- A. increases or decreases at a linear rate
- B. increases or decreases exponentially
- C. is always increasing and never decreasing
- D. is constant Discuss
- 6. What is the moving part of a linear variable differential transformer?
Options- A. Primary
- B. Secondary
- C. Diaphragm
- D. Core Discuss
- 7. Holding current for an SCR is best described as
Options- A. the minimum current required for turn-off
- B. the current required before an SCR will turn on
- C. the amount of current required to maintain conduction
- D. the gate current required to maintain conduction Discuss
- 8. What device is similar to an RTD but has a negative temperature coefficient?
Options- A. Strain gauge
- B. Thermistor
- C. Negative-type RTD
- D. Thermocouple Discuss
- 9. Which of the following performance specifications applies to a sample-and-hold circuit?
Options- A. Aperture time
- B. Aperture droop
- C. Feedback
- D. Acquisition jitter Discuss
- 10. What is the zero-voltage switch used for?
Options- A. To reduce radiation of high frequencies during turn-on of a high current to a load
- B. To control low-voltage circuits
- C. To provide power to a circuit when power is lost
- D. For extremely low-voltage applications Discuss
Measurement, Conversion and Control problems
Search Results
Correct Answer: quantization error
Correct Answer: is based on the gauge factor, but is typically less than an ohm
Correct Answer: both an error detector and a reference voltage
Correct Answer: greater than the feedback resistance
Correct Answer: increases or decreases at a linear rate
Correct Answer: Core
Correct Answer: the amount of current required to maintain conduction
Correct Answer: Thermistor
Correct Answer: Aperture time
Correct Answer: To reduce radiation of high frequencies during turn-on of a high current to a load
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.