logo

CuriousTab

CuriousTab

Discussion


Home Electronics Basic Op-Amp Circuits Comments

  • Question
  • The center frequency of a band-pass filter is always equal to the


  • Options
  • A. bandwidth
  • B. ?3 dB frequency
  • C. bandwidth divided by Q
  • D. geometric average of the critical frequencies

  • Correct Answer
  • geometric average of the critical frequencies 


  • Basic Op-Amp Circuits problems


    Search Results


    • 1. The formula shows that for a given capacitor, if the voltage changes at a constant rate with respect to time, the current will

    • Options
    • A. increase
    • B. decrease
    • C. be constant
    • D. decrease logarithmically
    • Discuss
    • 2. A zero-level detector is a

    • Options
    • A. comparator with a sine-wave output
    • B. comparator with a trip point referenced to zero
    • C. peak detector
    • D. limiter
    • Discuss
    • 3. If the input to a comparator is a sine wave, the output is a

    • Options
    • A. ramp voltage
    • B. sine wave
    • C. rectangular wave
    • D. sawtooth wave
    • Discuss
    • 4. Initially, the closed-loop gain (Acl) of a Wien-bridge oscillator should be

    • Options
    • A. Acl < 3
    • B. Acl > 3
    • C. 0
    • D. Acl ≅ 1
    • Discuss
    • 5. A two-pole high-pass active filter would have a roll-off rate of

    • Options
    • A. 40 dB/decade
    • B. ?40 dB/decade
    • C. 20 dB/decade
    • D. ?20 dB/decade
    • Discuss
    • 6. If the value of resistor Rf in an averaging amplifier circuit is equal to the value of one input resistor divided by the number of inputs, the output will be equal to

    • Options
    • A. the average of the individual inputs
    • B. the inverted sum of the individual inputs
    • C. the sum of the individual inputs
    • D. the inverted average of the individual inputs
    • Discuss
    • 7. A comparator is an example of a(n)

    • Options
    • A. active filter
    • B. current source
    • C. linear circuit
    • D. nonlinear circuit
    • Discuss
    • 8. A digital-to-analog converter is an application of the

    • Options
    • A. scaling adder
    • B. voltage-to-current converter
    • C. noninverting amplifier
    • D. adjustable bandwidth circuit
    • Discuss
    • 9. The ramp voltage at the output of an op-amp integrator

    • Options
    • A. increases or decreases at a linear rate
    • B. increases or decreases exponentially
    • C. is always increasing and never decreasing
    • D. is constant
    • Discuss
    • 10. In an averaging amplifier, the input resistances are

    • Options
    • A. equal to the feedback resistance
    • B. less than the feedback resistance
    • C. greater than the feedback resistance
    • D. unequal
    • Discuss


    Comments

    There are no comments.

Enter a new Comment