logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Time Response of Reactive Circuits See What Others Are Saying!
  • Question

  • In the given circuit, what must the pulse width and time between pulses be to allow the capacitor to

    In the given circuit, what must the pulse width and time between pulses be to allow the capacitor to completely charge by the end of each pulse and to completely discharge between each pulse?


  • Options
  • A. 940 µs
  • B. 2.82 ms
  • C. 3.76 ms
  • D. 4.7 ms

  • Correct Answer
  • 4.7 ms 

    • More questions

    • 1. XL = 2ΠfL

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. A voltage is induced across a conductor if it remains absolutely stationary within a magnetic field.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. 

      How much current flows in the circuit in the given circuit?


    • Options
    • A. 20 µA
    • B. 60 µA
    • C. 80 µA
    • D. 140 µA
      • Discuss
    • 4. The time constant of an inductive circuit is dependent on the circuit's resistance.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. When the output of a tri-state shift register is disabled, the output level is placed in a:

    • Options
    • A. float state
    • B. LOW state
    • C. high impedance state
    • D. float state and a high impedance state
      • Discuss
    • 6. 

      If the load doubled in value in the given circuit, what reflected resistance would the source see?


    • Options
    • A. 80 Ω
    • B. 400 Ω
    • C. 2 kΩ
    • D. 10 kΩ
      • Discuss
    • 7. In a 20 Vac series RC circuit, if 20 V is read across the resistor and 40 V is measured across the capacitor, the applied voltage is

    • Options
    • A. 45 Vac
    • B. 50 Vac
    • C. 60 Vac
    • D. 65 Vac
      • Discuss
    • 8. Capacitance is directly proportional to the dielectric constant and the distance between its plates and inversely proportional to the area of the plates.

    • Options
    • A. True
    • B. False
      • Discuss
    • 9. If both inputs are required to be ON for the output to be ON, the gate must be an AND gate.

    • Options
    • A. True
    • B. False
      • Discuss
    • 10. What circuit has the following frequency response?


    • Options
    • A. bandpass filter
    • B. high-pass filter
    • C. low-pass filter
    • D. integrator
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright İCuriousTab. All rights reserved.