logo

CuriousTab

CuriousTab

Discussion


Home Electronics Operational Amplifiers Comments

  • Question
  • The Schmitt trigger is a two-state device that is used for:


  • Options
  • A. pulse shaping
  • B. peak detection
  • C. input noise rejection
  • D. filtering

  • Correct Answer
  • pulse shaping 


  • Operational Amplifiers problems


    Search Results


    • 1. A noninverting closed-loop op-amp circuit generally has a gain factor:

    • Options
    • A. less than one
    • B. greater than one
    • C. of zero
    • D. equal to one
    • Discuss
    • 2. What three subcircuits does a phase locked loop (PLL) consist of?

    • Options
    • A. phase comparator, comparator, and VCO
    • B. phase comparator, bandpass filter, and VCO
    • C. phase comparator, bandpass filter, and demodulator
    • D. phase comparator, low-pass filter, and VCO
    • Discuss
    • 3. In order for an output to swing above and below a zero reference, the op-amp circuit requires:

    • Options
    • A. a resistive feedback network
    • B. zero offset
    • C. a wide bandwidth
    • D. a negative and positive supply
    • Discuss
    • 4. Another name for a unity gain amplifier is:

    • Options
    • A. difference amplifier
    • B. comparator
    • C. single ended
    • D. voltage follower
    • Discuss
    • 5. If an op-amp has one input grounded and the other input has a signal feed to it, then it is operating as what?

    • Options
    • A. Common-mode
    • B. Single-ended
    • C. Double-ended
    • D. Noninverting mode
    • Discuss
    • 6. An ideal operational amplifier has

    • Options
    • A. infinite output impedance
    • B. zero input impedance
    • C. infinite bandwidth
    • D. All of the above
    • Discuss
    • 7. With negative feedback, the returning signal:

    • Options
    • A. aids the input signal
    • B. is proportional to output current
    • C. opposes the input signal
    • D. is proportional to differential voltage gain
    • Discuss
    • 8. An ideal amplifier should have:

    • Options
    • A. high input current
    • B. zero offset
    • C. high output impedance
    • D. moderate gain
    • Discuss
    • 9. A series dissipative regulator is an example of a:

    • Options
    • A. linear regulator
    • B. switching regulator
    • C. shunt regulator
    • D. dc-to-dc converter
    • Discuss
    • 10. All of the following are basic op-amp input modes of operation EXCEPT

    • Options
    • A. inverting mode
    • B. common-mode
    • C. double-ended
    • D. single-ended
    • Discuss


    Comments

    There are no comments.

Enter a new Comment