logo

CuriousTab

CuriousTab

Discussion


Home Electronics Operational Amplifiers Comments

  • Question
  • In a PLL, to obtain lock, the signal frequency must:


  • Options
  • A. come within the lock range
  • B. be less than the capture frequency
  • C. come within the capture range
  • D. be greater than the capture frequency

  • Correct Answer
  • come within the capture range 


  • Operational Amplifiers problems


    Search Results


    • 1. The open-loop voltage gain (Aol) of an op-amp is the

    • Options
    • A. external voltage gain the device is capable of
    • B. internal voltage gain the device is capable of
    • C. most controlled parameter
    • D. same as Acl
    • Discuss
    • 2. An astable multivibrator is also known as a:

    • Options
    • A. one-shot multivibrator
    • B. free-running multivibrator
    • C. bistable multivibrator
    • D. monostable multivibrator
    • Discuss
    • 3. A portion of the output that provides circuit stabilization is considered to be:

    • Options
    • A. negative feedback
    • B. distortion
    • C. open-loop
    • D. positive feedback
    • Discuss
    • 4. If the input to a comparator is a sine wave, the output is a:

    • Options
    • A. ramp voltage
    • B. sine wave
    • C. rectangular wave
    • D. sawtooth wave
    • Discuss
    • 5. What is the output waveform of the circuit?


    • Options
    • A. sine wave
    • B. square wave
    • C. sawtooth wave
    • D. triangle wave
    • Discuss
    • 6. The common-mode voltage gain is

    • Options
    • A. smaller than differential voltage gain
    • B. equal to voltage gain
    • C. greater than differential voltage gain
    • D. None of the above
    • Discuss
    • 7. If an op-amp has one input grounded and the other input has a signal feed to it, then it is operating as what?

    • Options
    • A. Common-mode
    • B. Single-ended
    • C. Double-ended
    • D. Noninverting mode
    • Discuss
    • 8. Another name for a unity gain amplifier is:

    • Options
    • A. difference amplifier
    • B. comparator
    • C. single ended
    • D. voltage follower
    • Discuss
    • 9. In order for an output to swing above and below a zero reference, the op-amp circuit requires:

    • Options
    • A. a resistive feedback network
    • B. zero offset
    • C. a wide bandwidth
    • D. a negative and positive supply
    • Discuss
    • 10. What three subcircuits does a phase locked loop (PLL) consist of?

    • Options
    • A. phase comparator, comparator, and VCO
    • B. phase comparator, bandpass filter, and VCO
    • C. phase comparator, bandpass filter, and demodulator
    • D. phase comparator, low-pass filter, and VCO
    • Discuss


    Comments

    There are no comments.

Enter a new Comment