Discussion
Home ‣ Electronics ‣ Operational Amplifiers Comments
- Question
The open-loop voltage gain (Aol) of an op-amp is the
Options- A. external voltage gain the device is capable of
- B. internal voltage gain the device is capable of
- C. most controlled parameter
- D. same as Acl
- Correct Answer
- internal voltage gain the device is capable of
- 1. An astable multivibrator is also known as a:
Options- A. one-shot multivibrator
- B. free-running multivibrator
- C. bistable multivibrator
- D. monostable multivibrator Discuss
- 2. A portion of the output that provides circuit stabilization is considered to be:
Options- A. negative feedback
- B. distortion
- C. open-loop
- D. positive feedback Discuss
- 3. If the input to a comparator is a sine wave, the output is a:
Options- A. ramp voltage
- B. sine wave
- C. rectangular wave
- D. sawtooth wave Discuss
- 4. What is the output waveform of the circuit?
Options- A. sine wave
- B. square wave
- C. sawtooth wave
- D. triangle wave Discuss
- 5. A circuit whose output is proportional to the difference between the input signals is considered to be which type of amplifier?
Options- A. common-mode
- B. darlington
- C. differential
- D. operational Discuss
- 6. In a PLL, to obtain lock, the signal frequency must:
Options- A. come within the lock range
- B. be less than the capture frequency
- C. come within the capture range
- D. be greater than the capture frequency Discuss
- 7. The common-mode voltage gain is
Options- A. smaller than differential voltage gain
- B. equal to voltage gain
- C. greater than differential voltage gain
- D. None of the above Discuss
- 8. If an op-amp has one input grounded and the other input has a signal feed to it, then it is operating as what?
Options- A. Common-mode
- B. Single-ended
- C. Double-ended
- D. Noninverting mode Discuss
- 9. Another name for a unity gain amplifier is:
Options- A. difference amplifier
- B. comparator
- C. single ended
- D. voltage follower Discuss
- 10. In order for an output to swing above and below a zero reference, the op-amp circuit requires:
Options- A. a resistive feedback network
- B. zero offset
- C. a wide bandwidth
- D. a negative and positive supply Discuss
Operational Amplifiers problems
Search Results
Correct Answer: free-running multivibrator
Correct Answer: negative feedback
Correct Answer: rectangular wave
Correct Answer: square wave
Correct Answer: differential
Correct Answer: come within the capture range
Correct Answer: smaller than differential voltage gain
Correct Answer: Single-ended
Correct Answer: voltage follower
Correct Answer: a negative and positive supply
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.