Discussion
Home ‣ Electronics ‣ Operational Amplifiers Comments
- Question
The ratio between differential gain and common-mode gain is called:
Options- A. amplitude
- B. differential-mode rejection
- C. common-mode rejection
- D. phase
- Correct Answer
- common-mode rejection
- 1. In an open-loop op-amp circuit, whenever the inverting input (?) is negative relative to the noninverting input (+), the output will:
Options- A. swing negative
- B. close the loop
- C. be balanced
- D. swing positive Discuss
- 2. If the feedback/input resistor ratio of a feedback amplifier is 4.6 with 1.7 V applied to the noninverting input, what is the output voltage value?
Options- A. 7.82 V
- B. saturation
- C. cutoff
- D. 9.52 V Discuss
- 3. What is the difference between common-mode and differential-mode input signals?
Options- A. phase relationship
- B. voltage
- C. current
- D. apparent power Discuss
- 4. If a noninverting amplifier has an RIN of 1000 ohms and an RFB of 2.5 kilohms, what is the RIN voltage when 1.42 mV is applied to the correct input?
Options- A. 3.5 mV
- B. ground
- C. 1.42 mV
- D. 0.56 mV Discuss
- 5. If ground is applied to the (+) terminal of an inverting op-amp, the (?) terminal will:
Options- A. not need an input resistor
- B. be virtual ground
- C. have high reverse current
- D. not invert the signal Discuss
- 6. A circuit whose output is proportional to the difference between the input signals is considered to be which type of amplifier?
Options- A. common-mode
- B. darlington
- C. differential
- D. operational Discuss
- 7. What is the output waveform of the circuit?
Options- A. sine wave
- B. square wave
- C. sawtooth wave
- D. triangle wave Discuss
- 8. If the input to a comparator is a sine wave, the output is a:
Options- A. ramp voltage
- B. sine wave
- C. rectangular wave
- D. sawtooth wave Discuss
- 9. A portion of the output that provides circuit stabilization is considered to be:
Options- A. negative feedback
- B. distortion
- C. open-loop
- D. positive feedback Discuss
- 10. An astable multivibrator is also known as a:
Options- A. one-shot multivibrator
- B. free-running multivibrator
- C. bistable multivibrator
- D. monostable multivibrator Discuss
Operational Amplifiers problems
Search Results
Correct Answer: swing positive
Correct Answer: 9.52 V
Correct Answer: phase relationship
Correct Answer: 1.42 mV
Correct Answer: be virtual ground
Correct Answer: differential
Correct Answer: square wave
Correct Answer: rectangular wave
Correct Answer: negative feedback
Correct Answer: free-running multivibrator
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.