logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Operational Amplifiers Comments
  • Question

  • A circuit that uses an amplifier with passive filter elements is called a(n):


  • Options
  • A. relaxation oscillator
  • B. signal generator
  • C. differential amplifier
  • D. active filter

  • Correct Answer
  • active filter 

    • Operational Amplifiers problems

    Search Results

    • 1. How many leads does the TO-5 metal can package of an operational amplifier have?

    • Options
    • A. 8, 10, or 12
    • B. 6, 8, or 10
    • C. 8 or 14
    • D. 8 or 16
      • Discuss
    • 2. What is the cutoff frequency of this low-pass filter?


    • Options
    • A. 4.8 kHz
    • B. 3.8 kHz
    • C. 2.8 kHz
    • D. 1.8 kHz
      • Discuss
    • 3. With a differential gain of 50,000 and a common-mode gain of 2, what is the common-mode rejection ratio?

    • Options
    • A. ?87.9 dB
    • B. ?43.9 dB
    • C. 43.9 dB
    • D. 87.9 dB
      • Discuss
    • 4. The closed-loop voltage gain of an inverting amplifier equals:

    • Options
    • A. the ratio of the input resistance to the feedback resistance
    • B. the open-loop voltage gain
    • C. the feedback resistance divided by the input resistance
    • D. the input resistance
      • Discuss
    • 5. What starts a free-running multivibrator?

    • Options
    • A. a trigger
    • B. an input signal
    • C. an external circuit
    • D. nothing
      • Discuss
    • 6. What is the output waveform?


    • Options
    • A. sine wave
    • B. square wave
    • C. sawtooth wave
    • D. triangle wave
      • Discuss
    • 7. Input impedance [Zin(I)] of an inverting amplifier is approximately equal to:

    • Options
    • A. Ri
    • B. Rf + Ri
    • C. ?
    • D. Rf ? Ri
      • Discuss
    • 8. What is the output voltage?


    • Options
    • A. 15 V
    • B. 5 V
    • C. ?5 V
    • D. ?15 V
      • Discuss
    • 9. If ground is applied to the (+) terminal of an inverting op-amp, the (?) terminal will:

    • Options
    • A. not need an input resistor
    • B. be virtual ground
    • C. have high reverse current
    • D. not invert the signal
      • Discuss
    • 10. If a noninverting amplifier has an RIN of 1000 ohms and an RFB of 2.5 kilohms, what is the RIN voltage when 1.42 mV is applied to the correct input?

    • Options
    • A. 3.5 mV
    • B. ground
    • C. 1.42 mV
    • D. 0.56 mV
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.