logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Capacitors See What Others Are Saying!
  • Question

  • How long would it take the capacitor in the given circuit to completely discharge if the switch was

    How long would it take the capacitor in the given circuit to completely discharge if the switch was in position 2?


  • Options
  • A. 22 ms
  • B. 69 ms
  • C. 345 ms
  • D. 420 ms

  • Correct Answer
  • 420 ms 

    • More questions

    • 1. 

      In the given circuit, _____ are in series.


    • Options
    • A. R1 and R3
    • B. R3 and R5
    • C. R5 and R7
    • D. None of the above
      • Discuss
    • 2. A sixteen-input multiplexer will need three data select input control lines.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. R2 is open.


    • Options
    • A. True
    • B. False
      • Discuss
    • 4. When a load is connected to a voltage divider, the total resistance of the circuit will:

    • Options
    • A. decrease
    • B. double
    • C. increase
    • D. remain the same
      • Discuss
    • 5. NMOS devices use MOSFETs to implement the full range of logic gates using the universal NAND gate.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. The mimicking of an open/closed switch by a diode allows alternating current to be:

    • Options
    • A. rectified
    • B. regulated
    • C. controlled
    • D. attenuated
      • Discuss
    • 7. When the capacitance in an active high-pass filter increases, the critical frequency decreases.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. The induced voltage across a stationary conductor in a stationary magnetic field ___.

    • Options
    • A. equals 0 V
    • B. is usually very large
    • C. varies with time
    • D. depends on the strength of the magnetic field
      • Discuss
    • 9. What is the dielectric constant for ceramic?

    • Options
    • A. between 6 and 8000
    • B. 5.0
    • C. between 5 and 1000
    • D. 3000
      • Discuss
    • 10. A check of all power supply voltages should be made during the ________ method of troubleshooting.

    • Options
    • A. half-split
    • B. diagnosis
    • C. repair
    • D. final test
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.