Discussion
Home ‣ Biochemical Engineering ‣ Fermentation Reactors Comments
- Question
The growth of an organism on glucose is described by the following Monod model parameters: ?m = 0.5 h-1 and Ks =0.1 g.l-1, if the concentration of glucose in the feed is 10 g.l-1 and the dilution rate is set to 0.4 h-1, then the steady state concentration of glucose in the effluent will be
Options- A. 0 g.l-1
- B. 0.5 g.l-1
- C. 1.0 g.l-1
- D. 10 g.l-1
- Correct Answer
- 0.5 g.l-1
- 1. Immobilized cell reactors for wastewater treatment have the advantage of having/being
Options- A. higher cell concentration
- B. more stable and prevent washout
- C. higher dilution rate before the cells washout
- D. all of the above Discuss
- 2. In aerobic yeast fermentation for production of citric acid from alkanes using a fed-batch culture, why alkanes are slowly fed to the yeast?
Options- A. Citric acid is toxic to the cells
- B. Alkanes cause foaming
- C. Fast addition of alkanes will inhibit the cells and reduce oxygen transfer rates
- D. Fast addition of alkanes will cause the cells to grow too quickly Discuss
- 3. Low dissolved oxygen concentrations leads to
Options- A. low biomass yields
- B. high biomass yields
- C. no effect on biomass yields
- D. none of the above Discuss
- 4. Fluidized bed bioreactors provide higher mass transfer rates than packed bed bioreactors because
Options- A. mixing is higher in fluidized bed bioreactors
- B. particles move with the fluid in a fluidized bed bioreactor
- C. immobilized particles are smaller in the fluidized bed bioreactors
- D. all of the above Discuss
- 5. Mixing in an anaerobic sludge blanket reactor is due to
Options- A. rapid change in water temperatures throughout the reactor
- B. release of gases by the microbial populations
- C. swimming of microbes
- D. none of the above Discuss
- 6. The lowest yield of ATP /is in
Options- A. fermentation
- B. aerobic respiration
- C. anaerobic respiration
- D. same in (a), (b) and (c) Discuss
- 7. Which have the maximum resistance while transferring carbon dioxide from the bulk liquid to an air bubble?
Options- A. Moving through the gas liquid interface
- B. Moving through the bubble boundary layer
- C. Moving across the cell membrane
- D. Moving through the bulk liquid Discuss
- 8. Penetration theory assumes that turbulent eddies travel from the bulk of the phase to the interface where they remain constant for a constant exposure time (te). The model correlating KL, mass transfer coefficient and DAB, diffusivity can be expressed as
Options- A. KL = 2(DAB/?te)0.25
- B. KL = 2(DAB/?te)0.5
- C. KL = 2(DAB/?te)0.75
- D. KL = 2(DAB/?te) Discuss
- 9. Surface renewal theory predicts that the mass transfer coefficient is
Options- A. directly proportional to the square root of the molecular diffusivity
- B. inversely proportional to the square root of the molecular diffusivity
- C. directly proportional to the cube root of the molecular diffusivity
- D. indirectly proportional to the cube root of the molecular diffusivity Discuss
- 10. Which of the following would be best described as an axial flow impeller?
Options- A. An impeller with blades pitched at 45° to the vertical
- B. An impeller which directs liquid flow towards the base of the reactor
- C. Both (a) and (b)
- D. An impeller with blades pitched at 75° to the vertical Discuss
Fermentation Reactors problems
Search Results
Correct Answer: all of the above
Correct Answer: Fast addition of alkanes will inhibit the cells and reduce oxygen transfer rates
Correct Answer: low biomass yields
Correct Answer: particles move with the fluid in a fluidized bed bioreactor
Correct Answer: release of gases by the microbial populations
Correct Answer: fermentation
Correct Answer: Moving through the bubble boundary layer
Correct Answer: KL = 2(DAB/?te)0.5
Correct Answer: directly proportional to the square root of the molecular diffusivity
Correct Answer: Both (a) and (b)
Comments
There are no comments.Programming
Copyright ©CuriousTab. All rights reserved.