Discussion
Home ‣ Networking ‣ Networking Basics Comments
- Question
What PPP protocol provides dynamic addressing, authentication, and multilink?
Options- A. NCP
- B. HDLC
- C. LCP
- D. X.25
- Correct Answer
- LCP
ExplanationLink Control Protocol in the PPP stack provides dynamic addressing, authentication, and multilink. - 1. What are the two main types of access control lists (ACLs)?
- Standard
- IEEE
- Extended
- Specialized
Options- A. 1 and 3
- B. 2 and 4
- C. 3 and 4
- D. 1 and 2 Discuss
- 2. Which of the following commands will allow you to set your Telnet password on a Cisco router?
Options- A. line telnet 0 4
- B. line aux 0 4
- C. line vty 0 4
- D. line con 0 Discuss
- 3. What protocol does PPP use to identify the Network layer protocol?
Options- A. NCP
- B. ISDN
- C. HDLC
- D. LCP Discuss
- 4. How long is an IPv6 address?
Options- A. 32 bits
- B. 128 bytes
- C. 64 bits
- D. 128 bits Discuss
- 5. Which protocol does Ping use?
Options- A. TCP
- B. ARP
- C. ICMP
- D. BootP Discuss
- 6. Where is a hub specified in the OSI model?
Options- A. Session layer
- B. Physical layer
- C. Data Link layer
- D. Application layer Discuss
Networking Basics problems
Search Results
Correct Answer: 1 and 3
Explanation:
Standard and extended access control lists (ACLs) are used to configure security on a router.
Correct Answer: line vty 0 4
Explanation:
The command
line vty 0 4 places you in a prompt that will allow you to set or change your Telnet password.
Correct Answer: NCP
Explanation:
Network Control Protocol is used to help identify the Network layer protocol used in the packet.
Correct Answer: 128 bits
Explanation:
An IPv6 address is 128 bits long.
Correct Answer: ICMP
Explanation:
ICMP is the protocol at the Network layer that is used to send echo requests and replies.
Correct Answer: Physical layer
Explanation:
Hubs regenerate electrical signals, which are specified at the Physical layer.
Comments
There are no comments.Programming
Copyright ©CuriousTab. All rights reserved.