Discussion
Home ‣ Computer Science ‣ Automation System Comments
- Question
Timing using a TM990 micro¬computer:
Options- A. require an external timer added by the user
- B. is available on the standard CPU board
- C. can be handled in software
- D. both (b) and (c)
- E. None of the above.
- Correct Answer
- both (b) and (c)
- 1. What prevents a robotic instrument from running into other objects?
Options- A. negative image
- B. functional manipulators
- C. memory
- D. sensory devices
- E. None of the above Discuss
- 2. The program counter:
Options- A. decides which program to run
- B. counts the number of instructions that have been executed
- C. contains the address of the next instruction to be executed
- D. is where arithmetic is done in a computer.
- E. None of the above Discuss
- 3. Which of the following symbol modes are used to input of graphics to General CAD system?
Options- A. Live and Rectangle mode
- B. Arc and Circle mode
- C. Dimension and Alphanumeric mode
- D. All of the above
- E. None of the above Discuss
- 4. Flat panel displays are based on what type of technology?
Options- A. Direct view storage tube
- B. Very large-scale integration (VLSI)
- C. Solid state
- D. RGB monitor
- E. None of the above Discuss
- 5. Digital signals:
Options- A. can have three possible levels
- B. are assigned values of 1 or 0 depending on the voltage level
- C. have a sinusoidal shape.
- D. have a frequency measured in units of hertz
- E. None of the above Discuss
- 6. A program language:
Options- A. defines the form of the instruction
- B. is always machine dependent
- C. is never machine dependent
- D. All of the above
- E. None of the above Discuss
- 7. Which method is frequently used, especially in the early stages of design?
Options- A. The iterative design method
- B. The direct method
- C. The design selection method
- D. All of the above
- E. None of the above Discuss
- 8. Which of these controller types is the most accurate?
Options- A. Proportional plus integral
- B. Proportional
- C. Proportional plus derivative
- D. Three mode
- E. None of the above Discuss
- 9. A drum timer is a good example of:
Options- A. an output actuator
- B. an input sensor
- C. a position sensor
- D. a sequence controller
- E. None of the above Discuss
- 10. Using a microcomputer as a controller allows:
Options- A. faster cycle time
- B. simpler mechanical hardware
- C. more self diagnostics of the machine operation
- D. All of the above
- E. None of the above Discuss
Automation System problems
Search Results
Correct Answer: sensory devices
Correct Answer: contains the address of the next instruction to be executed
Correct Answer: All of the above
Correct Answer: Solid state
Correct Answer: are assigned values of 1 or 0 depending on the voltage level
Correct Answer: defines the form of the instruction
Correct Answer: The iterative design method
Correct Answer: Three mode
Correct Answer: a sequence controller
Correct Answer: All of the above
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.