logo

CuriousTab

CuriousTab

Discussion


Home Electrical Engineering Inductors See What Others Are Saying!
  • Question
  • An inductor and a resistor are in series with a sine wave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then


  • Options
  • A. VR ? VL
  • B. VL < VR
  • C. VL = VR
  • D. VL > VR

  • Correct Answer
  • VL > VR 


  • More questions

    • 1. In a Y-connected circuit, between each line voltage and the nearest phase voltage, there is a phase angle of

    • Options
    • A. 0°
    • B. 30°
    • C. 60°
    • D. 120°
    • Discuss
    • 2. The quality factor (Q) is the ratio of true power to apparent power.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. In an RC integrating circuit, the output voltage is taken across the capacitor.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. A resistance of 3.3 MΩ is connected across a 500 V source. The resulting current is approximately

    • Options
    • A. 15.1 µA
    • B. 151 µA
    • C. 66 mA
    • D. 660 mA
    • Discuss
    • 5. The number of megohms in 0.03 kilohms is

    • Options
    • A. 0.00002 MΩ
    • B. 0.0002 MΩ
    • C. 3 × 10?5 MΩ
    • D. either 0.00002 MΩ or 0.0002 MΩ
    • Discuss
    • 6. The internal resistance of a 30,000 ohm/volt voltmeter set on its 50 V range is

    • Options
    • A. 15,000 Ω
    • B. 150,000 Ω
    • C. 1,500,000 Ω
    • D. 15,000,000 Ω
    • Discuss
    • 7. An inductor, a 1 kΩ resistor, and a switch are connected in series across a 6 V battery. At the instant the switch is closed, the inductor voltage is

    • Options
    • A. 0 V
    • B. 6 V
    • C. 12 V
    • D. 4 V
    • Discuss
    • 8. A 1.2 kΩ resistor is in series with a 15 mH coil across a 10 kHz ac source. The magnitude of the total impedance is

    • Options
    • A. 152.6 Ω
    • B. 1,526 Ω
    • C. 1,200 Ω
    • D. 942 Ω
    • Discuss
    • 9. For 12 V and 40 mA, the power is

    • Options
    • A. 480 mW
    • B. 0.480 W
    • C. 480,000 µW
    • D. all of the above
    • Discuss
    • 10. Determine VTH when R1 is 180 Ω and XL is 90 Ω.


    • Options
    • A. 135∠63.4° V
    • B. 13.5∠63.4° V
    • C. 12.2∠0° V
    • D. 122∠0° V
    • Discuss


    Comments

    There are no comments.

Enter a new Comment