logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Matching Questions See What Others Are Saying!
  • Question
  • Match the following:

    List I List II
    A. RC coupled amplifier 1. Very low drift
    B. Tuned amplifier 2. Flat frequency response from zero frequency onwards
    C. Chopper stabilized amplifier 3. Flat frequency response with upper and lower cut off frequency
    D. DC amplifier 4. Peak in gain frequency response


  • Options
  • A. A-4, B-3, C-1, D-2
  • B. A-3, B-4, C-2, D-1
  • C. A-3, B-4, C-1, D-2
  • D. A-4, B-3, C-2, D-1

  • Correct Answer
  • A-3, B-4, C-1, D-2 


  • More questions

    • 1. A microstrip line has ?r = 9. The normalised wavelength is about

    • Options
    • A. 10
    • B. 2
    • C. 1
    • D. 0.4
    • Discuss
    • 2. In p-n-p transistor the current IE has two components viz. IEP due to injection of holes from p-region to n-region and IE due to injection of electrons from n-region to p-region. Then

    • Options
    • A. IEp and IEn are almost equal
    • B. IEp >> IEn
    • C. IEn >> IEp
    • D. either (a) or (c)
    • Discuss
    • 3. A Shockley diode can be used

    • Options
    • A. in place of SCR
    • B. as a trigger switch for SCR
    • C. in place of UJT
    • D. both in place of SCR and as a trigger switch for SCR
    • Discuss
    • 4. The symbol in figure is for

    • Options
    • A. SUS
    • B. SBS
    • C. SCS
    • D. Shockley diode
    • Discuss
    • 5. Consider the following statements

      1. Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
      2. For a given value of TM10 cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
      3. Ridge wave guide has higher conductor losser than a rectangular waveguide.
      4. Ridge guide has higher conductor losser than a rectangular waveguide.
      Which of the above statements are correct?

    • Options
    • A. 1 and 2 only
    • B. 1, 2 and 3 only
    • C. 2 and 3 only
    • D. All
    • Discuss
    • 6. Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity

    • Options
    • A. increases
    • B. decreases
    • C. may increase or decrease
    • D. remains the same
    • Discuss
    • 7. The current rating of a cable depends on

    • Options
    • A. length of cable
    • B. diameter of cable
    • C. both length and diameter of cable
    • D. none of the above
    • Discuss
    • 8. A voltmeter using thermocouples measures

    • Options
    • A. rms value
    • B. peak value
    • C. average value
    • D. peak to peak value
    • Discuss
    • 9. In the given figure the input is x(t) = A sin ?t. The steady state output y(t) =

    • Options
    • A. A sin (?t + ?) where ? = tan-1 |G(j?)|
    • B. |G(j?)| A sin [?t + ?G(j?)]
    • C. |G(j?)| A sin [2?t + ?G(j?)]
    • D. A G(j?) sin [?t + ?G(j?)]
    • Discuss
    • 10. Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz

    • Options
    • A. 30, 60 and 70 kHz
    • B. 3, 6 and 7 kHz
    • C. 30, 60 and 70 MHz
    • D. 3, 6 and 7 GHz
    • Discuss


    Comments

    There are no comments.

Enter a new Comment