CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Electronics and Communication Engineering
‣
Satellite Communication
Comments
Question
In a stop-and-wait ARQ system, the transmitting terminal
Options
A. waits for positive or negative acknowled-gement from the receiving terminal after sending a block
B. sends another block if positive acknowledge is received through ACK character
C. resends the previous block if negative acknowledgement is received through a NAK character
D. does not wait for acknowledgement after sending a block
Correct Answer
does not wait for acknowledgement after sending a block
Satellite Communication problems
Search Results
1. In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
Options
A. gives a narrow beam shining into space
B. results in lesser signal attenuation
C. gives better beam-shaping
D. is easier to polarize a high frequency beam
Show Answer
Scratch Pad
Discuss
Correct Answer: gives a narrow beam shining into space
2. Which one of the following statement is correct?
Options
A. Satellite spacing is not affected by the bandwidth of the transmitting earth station
B. Beamwidth is independent of antenna size and frequency band used
C. The width of a beam in space is inversely proportional to the width of the transmitting antenna
D. Use of high-frequency bands permits less number of satellites to share the orbit
Show Answer
Scratch Pad
Discuss
Correct Answer: The width of a beam in space is inversely proportional to the width of the transmitting antenna
3. A transponder is a satellite equipment which
Options
A. receives a signal from Earth station and amplifies
B. changes the frequency of the received signal
C. retransmits the received signal
D. does all of the above-mentioned functions
Show Answer
Scratch Pad
Discuss
Correct Answer: does all of the above-mentioned functions
4. At present, the radio-frequency band mainly used by most satellites is
Options
A. EHF
B. UHF
C. VHF
D. SHF
Show Answer
Scratch Pad
Discuss
Correct Answer: SHF
5. Power received from Sun per m
2
surface area of a geosynchronous satellite in nearly __________ watt.
Options
A. 100
B. 500
C. 2000
D. 1000
Show Answer
Scratch Pad
Discuss
Correct Answer: 1000
6. The angle subtended by earth at geostationary communication satellite is
Options
A. 17.34°
B. 51.4°
C. 120°
D. 60°
Show Answer
Scratch Pad
Discuss
Correct Answer: 17.34°
7. The geostationary communication satellite APPLE is parked in the equatorial orbit at
Options
A. 102° E longitude over Sumatra
B. 90° E longitude over Bangladesh
C. 74° E longitude over India
D. 67° E longitude over Pakistan
Show Answer
Scratch Pad
Discuss
Correct Answer: 102° E longitude over Sumatra
8. The ending part of the popular teleserial Mahabharat will be beamed to the viewers
Options
A. WESTAT
B. INSAT-IC
C. ARABSAT
D. INSAT-ID
Show Answer
Scratch Pad
Discuss
Correct Answer: ARABSAT
9. In satellite communication, frequency modulation is used because satellite channel has
Options
A. small bandwidth and negligible noise
B. large bandwidth and severe noise
C. maximum bandwidth and minimum noise
D. high modulation index
Show Answer
Scratch Pad
Discuss
Correct Answer: large bandwidth and severe noise
10. While keeping the down-link frequency constant, the diameter of a satellite antenna is reduced by half. To offer the same EIRP over the increased coverage area, the
RF
output power has to be increases by a factor of
Options
A. 2
B. 4
C. 8
D. 16
Show Answer
Scratch Pad
Discuss
Correct Answer: 4
Comments
There are no comments.
Enter a new Comment
Save
More in Electronics and Communication Engineering:
Analog Electronics
Automatic Control Systems
Communication Systems
Digital Electronics
Electromagnetic Field Theory
Electronic Devices and Circuits
Exam Questions Papers
Matching Questions
Materials and Components
Measurements and Instrumentation
Microprocessors
Microwave Communication
Networks Analysis and Synthesis
Power Electronics
Radio Receivers
Satellite Communication
Signals and Systems