Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
The instrument which has all the features of try-square, bevel protractor, rule and scriber, is
Options- A. outside micrometer
- B. inside micrometer
- C. depth gauge micrometer
- D. combination set
- Correct Answer
- combination set
- 1. The algebraic difference between the minimum limit and the basic size is called
Options- A. actual deviation
- B. upper deviation
- C. lower deviation
- D. fundamental deviation Discuss
- 2. A pattern maker's shrinkage rule considers
Options- A. all pattern allowances
- B. only shrinkage allowance
- C. all materials to be cast
- D. all materials of the pattern Discuss
- 3. In average work, the tolerance produced by investment casting method is
Options- A. ±0.05 mm
- B. +0.2 mm
- C. +05 mm
- D. +1 mm Discuss
- 4. The tolerance produced by shell moulding process of casting is
Options- A. +0.05 mm
- B. ±0.2 mm
- C. +0.5 mm
- D. ±1 mm Discuss
- 5. Galvanising is a
Options- A. zinc diffusion process
- B. process of coating zinc by hot dipping
- C. process used for making thin phosphate coating on steel
- D. none of the above Discuss
- 6. In welding copper alloys with TIG arc welding
Options- A. direct current with straight polarity is used
- B. direct current with reversed polarity is used
- C. alternating current is used
- D. any one of these Discuss
- 7. In a hot chamber die casting machine
Options- A. ferrous alloys with low melting temperature are casted
- B. ferrous alloys with high melting temperature are casted
- C. non-ferrous alloys with low melting temperature are casted
- D. non-ferrous alloys with high melting temperature are casted Discuss
- 8. The low pressure acetylene is produced at the welding site by the chemical reaction between water and calcium carbonate.
Options- A. Correct
- B. Incorrect Discuss
- 9. When a hole or cavity to be cored is not in line with the parting surface, then a __________ is used.
Options- A. horizontal core
- B. vertical core
- C. drop core
- D. balanced core Discuss
- 10. The temperature at which the new grains are formed in the metal is called
Options- A. lower critical temperature
- B. upper critical temperature
- C. eutectic temperature
- D. recrystallisation temperature Discuss
Workshop Technology problems
Search Results
Correct Answer: lower deviation
Correct Answer: only shrinkage allowance
Correct Answer: ±0.05 mm
Correct Answer: ±0.2 mm
Correct Answer: process of coating zinc by hot dipping
Correct Answer: direct current with straight polarity is used
Correct Answer: non-ferrous alloys with low melting temperature are casted
Correct Answer: Incorrect
Correct Answer: drop core
Correct Answer: recrystallisation temperature
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.