logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Workshop Technology See What Others Are Saying!
  • Question
  • The blank diameter used in thread rolling will be


  • Options
  • A. equal to minor diameter of the thread
  • B. equal to pitch diameter of the thread
  • C. a little larger than the minor diameter of the thread
  • D. a little larger than the pitch diameter of the thread

  • Correct Answer
  • a little larger than the minor diameter of the thread 


  • More questions

    • 1. The expansion ratio (r) is the ratio of (where v1 = Volume at the beginning of expansion, and v2 = Volume at the end of expansion)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 2. The efficiency of a riveted joint is the ratio of the strength of the joint to the strength of the solid plate.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. In case of solids, the heat transfer takes place according to radiation.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 4. The emissivity for a black body is

    • Options
    • A. 0
    • B. 0.5
    • C. 0.75
    • D. 1
    • Discuss
    • 5. The coefficient of performance of Heat Pump is always __________ one.

    • Options
    • A. equal to
    • B. less than
    • C. greater than
    • Discuss
    • 6. In permanent mould casting method

    • Options
    • A. molten metal is poured in a metallic mould, retained in the mould long enough for the outer skin to solidify and finally mould is turned over to remove molten metal still in molten condition
    • B. molten metal is poured and allowed to solidify while the mould is revolving
    • C. molten metal is forced into mould under high pressure
    • D. none of the above
    • Discuss
    • 7. In a psychrometric chart, specific humidity (moisture content) lines are

    • Options
    • A. vertical and uniformly spaced
    • B. horizontal and uniformly spaced
    • C. horizontal and non-uniformly spaced
    • D. curved lines
    • Discuss
    • 8. If the masses of both the bodies, as shown in the below figure, are reduced to 50 percent, then tension in the string will be

    • Options
    • A. same
    • B. half
    • C. double
    • Discuss
    • 9. A pressure vessel is said to be a thick shell, when

    • Options
    • A. it is made of thick sheets
    • B. the internal pressure is very high
    • C. the ratio of wall thickness of the vessel to its diameter is less than 1/10.
    • D. the ratio of wall thickness of the vessel to its diameter is greater than 1/10.
    • Discuss
    • 10. Slip of a reciprocating pump is defined as the

    • Options
    • A. ratio of actual discharge to the theoretical discharge
    • B. sum of actual discharge and the theoretical discharge
    • C. difference of theoretical discharge and the actual discharge
    • D. product of theoretical discharge and the actual discharge
    • Discuss


    Comments

    There are no comments.

Enter a new Comment