Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The lead screw of a lathe has __________ threads.
Options- A. single start
- B. double start
- C. multi-start
- D. any one of these
- Correct Answer
- single start
- 1. The tool made of cemented carbide wear out faster at
Options- A. slow speeds
- B. medium speeds
- C. fast speeds
- D. very fast speeds Discuss
- 2. During adiabatic saturation process on unsaturated air __________ remains constant.
Options- A. relative humidity
- B. dew point temperature
- C. dry bulb temperature
- D. wet bulb temperature Discuss
- 3. Which of the following statement is wrong?
Options- A. The heat transfer in liquid and gases takes place according to convection.
- B. The amount of heat flow through a body is dependent upon the material of the body.
- C. The thermal conductivity of solid metals increases with rise in temperature,
- D. Logarithmic mean temperature difference is not equal to the arithmetic mean temperature difference. Discuss
- 4. As relative humidity decreases, the dew point temperature will be __________ wet bulb temperature.
Options- A. same as
- B. lower than
- C. higher man Discuss
- 5. The heat transfer by conduction through a thick sphere is same as through a thick cylinder.
Options- A. True
- B. False Discuss
- 6. The cutting tool in a milling machine is mounted on
Options- A. spindle
- B. arbor
- C. column
- D. knee Discuss
- 7. Drilling is an example of
Options- A. orthogonal cutting
- B. oblique cutting
- C. simple cutting
- D. uniform cutting Discuss
- 8. The lip angle of a single point tool is usually
Options- A. 20° to 40°
- B. 40° to 60°
- C. 60° to 80°
- D. none of these Discuss
- 9. The work or surface speed for cylindrical grinding varies from
Options- A. 5 to 10 m/min
- B. 10 to 20 m/min
- C. 20 to 30 m/min
- D. 40 to 60 m/min Discuss
- 10. Side rake angle of a single point cutting tool is the angle
Options- A. by which the face of the tool is inclined towards back
- B. by which the face of the tool is inclined sideways
- C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
- D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Discuss
Production Engineering problems
Search Results
Correct Answer: slow speeds
Correct Answer: wet bulb temperature
Correct Answer: The thermal conductivity of solid metals increases with rise in temperature,
Correct Answer: lower than
Correct Answer: False
Correct Answer: arbor
Correct Answer: oblique cutting
Correct Answer: 60° to 80°
Correct Answer: 20 to 30 m/min
Correct Answer: by which the face of the tool is inclined sideways
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.