logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Engineering Mechanics See What Others Are Saying!
  • Question

  • The algebraic sum of the resolved parts of a number of forces in a given direction is equal to the resolved part of their resultant in the same direction. This is known as


  • Options
  • A. principle of independence of forces
  • B. principle of resolution of forces
  • C. principle of transmissibility of forces
  • D. none of these

  • Correct Answer
  • principle of resolution of forces 

    • More questions

    • 1. According to Bernoulli's equation

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 2. If the condenser temperature is kept constant, the coefficient of performance of a refrigeration cycle increases with the increase in evaporator temperature.

    • Options
    • A. Yes
    • B. No
      • Discuss
    • 3. When the piston is at T.D.C, the volume above the piston in the combustion chamber is the

    • Options
    • A. clearance volume
    • B. cylinder volume
    • C. exhaust volume
    • D. none of these
      • Discuss
    • 4. During dehumidification process, the relative humidity

    • Options
    • A. remains constant
    • B. increases
    • C. decreases
      • Discuss
    • 5. A diamond locating pin is used in jigs and fixtures because

    • Options
    • A. diamond is very hard and wear resistant
    • B. it occupies very little space
    • C. it helps in assembly with tolerance on centre distance
    • D. it has a long life
      • Discuss
    • 6. The maximum temperature in a gas turbine is

    • Options
    • A. 200°C
    • B. 500°C
    • C. 700°C
    • D. 1000°C
      • Discuss
    • 7. The flow at critical depth in an open channel is called torrential flow.

    • Options
    • A. Yes
    • B. No
      • Discuss
    • 8. Glazing in grinding wheels takes place when the

    • Options
    • A. wheel is too hard or wheel revolves at a very high speed
    • B. wheel is too soft or wheel revolves at a very slow speed
    • C. wheel is too hard and wheel revolves at very slow speed
    • D. wheel is too soft and wheel revolves at a very high speed
      • Discuss
    • 9. The swing diameter over carriage is always less than the swing diameter over bed.

    • Options
    • A. Yes
    • B. No
      • Discuss
    • 10. The relation between Young's modulus (E), shear modulus (C) and bulk modulus (K) is given by

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.