logo

CuriousTab

CuriousTab

Discussion


Home Certification CISCO Certification Comments

  • Question
  • Which of the following is correct?


  • Options
  • A. Full- duplex Ethernet uses one pair of wires
  • B. Full- duplex Ethernet uses two pairs of wires
  • C. Half- duplex Ethernet uses two pairs of wires
  • D. Full- duplex Ethernet uses three pairs of wires

  • Correct Answer
  • Full- duplex Ethernet uses two pairs of wires 


  • CISCO Certification problems


    Search Results


    • 1. In the operation of CSMA/CD, which host(s) have priority after the expiration of the backoff algorithm?

    • Options
    • A. All hosts have equal priority
    • B. The two hosts that caused the collision will have equal priority
    • C. The host that sent the jam signal after the collision
    • D. The host with the highest MAC address
    • Discuss
    • 2. What is the specific term for the unwanted signal interference from adjacent pairs in the cable?

    • Options
    • A. EMI
    • B. RFI
    • C. Crosstalk
    • D. Attenuation
    • Discuss
    • 3. When making a HyperTerminal connection, what must the bit rate be set to?

    • Options
    • A. 2400bps
    • B. 1200bps
    • C. 9600bps
    • D. 6400bps
    • Discuss
    • 4. Which of the following is part of the IEEE 802.3u standard?

    • Options
    • A. 100Base2
    • B. 10Base5
    • C. 100Base-TX
    • D. 1000Base-T
    • Discuss
    • 5. You want to implement a network medium that is not susceptible to EMI. Which type of cabling should you use?

    • Options
    • A. Thicknet coax
    • B. Thinnet coax
    • C. Category 5 UTP cable
    • D. Fiber-optic cable
    • Discuss
    • 6. Convert the following from decimal IP address to binary format. 192.168.10.15
    • Discuss
    • 7. Convert the following from binary format to hexadecimal 11001010.11110101.10000011.11101011
    • Discuss
    • 8. A static map to the S-AMER location is required. Which command should be used to create this map? A. frame-relay map ip 172.16.1.3 704 broadcast B. frame-relay map ip 172.16.1.3 196 broadcast C. frame-relay map ip 172.16.1.3 702 broadcast D. frame-relay map ip 172.16.1.3 344 broadcast
    • Discuss
    • 9. As a Cisco technician, you need to know EIGRP protocol very well. Which of the following is true about EIGRP successor routes? (Choose two) A. A successor route is used by EIGRP to forward traffic to a destination B. Successor routes are stored in the neighbor table following the discovery process C. Successor routes are flagged as "active" in the routing table D. A successor route may be backed up by a feasible successor route
    • Discuss
    • 10. Users on the 192.168.10.0/24 network must access files located on the Server 1. What route could be configured on router R1 for file requests to reach the server? A. IP route 0.0.0.0 0.0.0.0 s0/0/0 B. IP route 0.0.0.0 0.0.0.0 209.165.200.226 C. IP route 209.165.200.0 255.255.255.0 192.168.10.250 D. IP route 192.168.10.0 255.255.255.0 209.165.100.250
    • Discuss


    Comments

    There are no comments.

Enter a new Comment