Name 5 different addressing modes?

Correct Answer: There are 12 interrupts in 8085

Correct Answer: 3MHz is the maximum clock frequency for 8085

Correct Answer: RST 45 is called as TRAP

Correct Answer: Yes, it can be used, if an accurate clock frequency is not required also the component cost is low compared to LC or Crystal

Correct Answer: Yes so if 8529 gives interrupt then it will be serviced immediately but since INTA pin is left hanging the INSR bit will never be set and so whenever my interrupt occurs depending upon priority it will be serviced also the ISR address for all interrupts will be same ie 0024H Interrupt via trap is nonmaskable, so it will be serviced immediately

Correct Answer: TRAP has the highest priority there are 2 types of interrupts external and internal NMI has highest priority among all external interrupts, TRAP has highest priority among all internal interrupts

Correct Answer: RST0, RST1, RST2, RST3, RST4, RST5, RST6, RST7

Correct Answer: TRAP, RST75, RST65, RST55, INTR

Correct Answer: in 8085 the interrupts are classified as Hardware and Software interrupts

Correct Answer: A bus is a group of conducting lines that carriers data, address, & control signals A bus is two or many wire communication method A bus which communicate between two active devices, it may transfer address, data etc