Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Logic Families and Their Characteristics
Why is a decoupling capacitor needed for TTL ICs and where should it be connected?
to block dc, connect to input pins
to reduce noise, connect to input pins
to reduce the effects of noise, connect between power supply and ground
Correct Answer:
to reduce the effects of noise, connect between power supply and ground
← Previous Question
Next Question→
More Questions from
Logic Families and Their Characteristics
An open collector output can ________ current, but it cannot ________.
The TTL HIGH level source current is higher than the LOW level sinking current.
The most common TTL series ICs are:
The rise time (tr) is the time it takes for a pulse to rise from its ________ point up to its ________ point. The fall time (tf) is the length of time it takes to fall from the ________ to the ________ point.
Ten TTL loads per TTL driver is known as:
Why is a pull-up resistor needed for an open collector gate?
If all inputs to a TTL NAND gate are low, what is the ON, OFF condition of each transistor in the circuit?
Assume that a particular IC has a supply voltage (Vcc) equal to +5 V and ICCH = 10 mA and ICCL = 23 mA. What is the power dissipation for the chip?
Fan-out is determined by taking the ________ result(s) of ________.
Why is a pull-up resistor needed when connecting TTL logic to CMOS logic?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments