Curioustab

Home » Digital Electronics » Combinational Logic Circuits

A 74HC147 priority encoder has ten active-LOW inputs and four active-LOW outputs. What would be the state of the four outputs if inputs 4 and 5 are LOW and all other inputs are HIGH?

Correct Answer:

← Previous Question Next Question→

More Questions from Combinational Logic Circuits

A decoder can be used as a demultiplexer by ________.
Which of the following combinations of logic gates can decode binary 1101?
An output gate is connected to four input gates; the circuit does not function. Preliminary tests with the DMM indicate that the power is applied; scope tests show that the primary input gate has a pulsing signal, while the interconnecting node has no signal. The four load gates are all on different ICs. Which instrument will best help isolate the problem?
A full-adder has a Cin = 0. What are the sum (∑) and the carry (Cout) when A = 1 and B = 1?
Two 4-bit binary numbers (1011 and 1111) are applied to a 4-bit parallel adder. The carry input is 1. What are the values for the sum and carry output?
The device shown here is most likely a ________.
Which of the following combinations cannot be combined into K-map groups?
Which of the figures in figure (a to d) is equivalent to figure (e)?
Which of the figures shown below represents the exclusive-NOR gate?
How many outputs would two 8-line-to-3-line encoders, expanded to a 16-line-to-4-line encoder, have?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion