Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Computer Science
»
Automation System
The general CAD system was development by considering a wide range of possible uses of such a system.
Mechanical engineering design
Animation and graphic design
Structural engineering design and Electronic circuit design
All of the above
None of the above
Correct Answer:
All of the above
← Previous Question
Next Question→
More Questions from
Automation System
Having compatibility and commonality in and between vendors' equipment is called:
An up/down counter used in a TI510PC has three inputs. Which of the following is not one of them?
The "end-effector" of a robot:
Which of the following are kinds of instructions?
Relay ladder logic is used in a PC because:
Which of the following is often used as an alternative to the light pen or in association with storage tube displays?
Programmable controllers:
The difference between CAD and CAM is that CAD software is directed at product design while CAM software is:
What two disciplines are usually tied by a common data base?
Standard computer control products:
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments