Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Stoichiometry
Raoult's law states that 'the equilibrium vapor pressure that is exerted by a component in a solution is proportional to the mole fraction of that component'. This generalisation is based on the assumption that the
sizes of the component molecules are approximately equal.
attractive forces between like and unlike molecules are approximately equal.
component molecules are non-polar and no chemical combination or molecular association between unlike molecules takes place in the formation of the solution.
all (a), (b) & (c).
Correct Answer:
all (a), (b) & (c).
← Previous Question
Next Question→
More Questions from
Stoichiometry
A liquid is in equilibrium with its vapor at its boiling point. On an average, the molecules in the liquid and gaseous phases have equal
Pick out the correct conversion.
The osmotic pressure of a solution is directly proportional to the
Two solutions A1 and A2 have pH value of 2 and 6 respectively. It implies that the solution
The molecular velocity of a real gas is proportional to (where, T = absolute temperature of the gas).
In case of vapor-liquid equilibria, which of the following does not account for gas phase deviation from ideality?
Which of the following is followed by an ideal solution?
The vapor pressure of the solvent decreased by 10 mm Hg, when a non-volatile solute was added to the solvent. The mole fraction of the solute in the solution is 0.2. What should be the mole fraction of the solvent, if the decrease in vapor pressure of the solvent is required to be 20 mm Hg.?
If the pressure of a gas is reduced to half & its absolute temperature is doubled, then the volume of the gas will
"The total volume occupied by a gaseous mixture is equal to the sum of the pure component volumes". This is the __________ law.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments