Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
Generally, no corrosion allowance in wall thickness of a part is required, if the thickness is more than __________ mm.
10
20
30
5
Correct Answer:
30
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
An adequate clearance between the tray and the shell wall of a distillation column is provided to
In a distillation column, the minimum residence time for liquid in the downspout is about __________ seconds.
Pick out the wrong statement about the design of a sieve plate column.
The circumferential (hoop) stress in a thin walled cylinderical vessel under internal pressure is
In case of a continuous distillation column, increase in reflux ratio may result in the
Floating head heat exchangers are used for the
In a shell and tube heat exchanger, tube side __________ of the mass velocity.
In packed towers provided with saddle packing, liquid redistributors are positioned at every __________ times column diameter or 6 metres whichever is less.
Thin spherical shells subjected to internal pressure, develop __________ stresses.
The maximum liquid gradient over a tray must not exceed
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments