Curioustab

Home » Chemical Engineering » Process Control and Instrumentation

The time constant of a unity gain, first order plus time delay process is 5 min. If the phase lag at a frequency of 0.2 rad/min is 60°, then the dead time (in minutes) is

5π/12
π/6
π/12
π/3

Correct Answer: 5π/12

← Previous Question Next Question→

More Questions from Process Control and Instrumentation

In a second order under damped system, the
In an exothermic chemical reactor, the manipulated variable is the flow rate of
The offset introduced by proportional controller with gain Kcin response of first order system can be reduced by
Helium gas constant volume thermometer is suitable for the measurement of a temperature of __________ °C.
The inverse Laplace transform of the function is
Dilatometer is used to measure
The transfer function of a first order system is
Optical activity of a solution can be determined using a
Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as :
__________ stability method uses open loop transfer function.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion