CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Electronic Principles problems
1. What is the phase shift between total current and voltage, if 100 ohm resistor connected in parallel with an inductor that has a reactance of 200W?
Options
A. 0 degree
B. 26.6 degree
C. 90 degree
D. 180 degree
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: 26.6 degree
2. The peak value of a sine waveform is:
Options
A. the amplitude at 70.7% of the maximum value
B. the amplitude at 90% of the maximum value
C. the amplitude at 1.41 times the maximum value
D. the maximum positive or negative value
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: the maximum positive or negative value
3. The basic unit of measurement for resistance is the:
Options
A. volt
B. ampere
C. ohm
D. watt
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: ohm
4. If N1/N2 = 2, and the primary voltage is 120 V, what is the secondary voltage?
Options
A. 0 V
B. 36 V
C. 40 V
D. 60 V
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: 60 V
5. Current is
Options
A. The flow of charged particles through a material
B. An imbalance of electrical charges
C. The force that causes electrons to flow
D. The number of free electrons in an atom
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: The flow of charged particles through a material
6. Which one of the following is most likely used for measuring the rate of electron flow?
Options
A. Voltmeter
B. Ammeter
C. Wattmeter
D. Ohmmeter
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: Ammeter
7. What is the difference between the kinds of charges for an electron and a proton?
Options
A. An electron has a positive charge and a proton has no charge
B. An electron has a positive charge and a proton has a negative charge
C. An electron has a negative charge and a proton has a positive charge
D. An electron has a negative charge and a proton has no charge
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: An electron has a negative charge and a proton has a positive charge
8. An ideal voltage source has
Options
A. Zero internal resistance
B. Infinite internal resistance
C. A load dependent voltage
D. A load-dependent current
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: Zero internal resistance
9. Which one of the following phrases most accurately describes a purely capacitive circuit?
Options
A. Resistances provide the only opposition to current flow
B. Capacitive reactance provides the only opposition to current flow
C. The ac voltage leads the current by 90 degree
D. Combinations of resistance and capacitive reactance provide any opposition to current flow
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: Capacitive reactance provides the only opposition to current flow
10. What is the inductive reactance of a 2-H coil operating at 60 Hz?
Options
A. 754 Ohm
B. 30 Ohm
C. 60 Ohm
D. 120 Ohm
E. None of the above
Show Answer
Scratch Pad
Discuss
Correct Answer: 754 Ohm
First
19
20
21
...
..
22
23
Last
More in Computer Science:
Artificial Intelligence
Automation System
Computer Fundamentals
Computer Hardware
Database Systems
Digital Computer Electronics
Disk Operating System (DOS)
Electronic Principles
Language Processors
Linux
Management Information Systems
Networking
Object Oriented Programming Using C++
Operating Systems Concepts
System Analysis and Design
Unix
Windows 2000 Server
Windows NT