Automation System problems
- 1. The integrated circuit:
Options- A. often is called a "chip"
- B. led to the development of the transistor
- C. has revolutionized electronics
- D. (b) and (c)
- E. None of the above Discuss
Correct Answer: (b) and (c)
- 2. The concept of a general CAD system was that it should provide:
Options- A. A system for handling user actions.
- B. A system for the operation of applications programming.
- C. A set of basic system functions and utilities.
- D. All of the above
- E. None of the above Discuss
Correct Answer: All of the above
- 3. The "walk-through" method of programming a robot involves:
Options- A. walking through your suggested procedure with your supervisor prior to programming
- B. physically moving the robot through all the motions it is to repeat
- C. moving the robot from one location to another
- D. All of the above.
- E. None of the above Discuss
Correct Answer: physically moving the robot through all the motions it is to repeat
- 4. What is offset error?
Options- A. the difference between the sensor input and the absolute sensed parameter.
- B. the difference between the controller output and the setting of the manipulated variable.
- C. the difference between the control setpoint value and the actual value.
- D. All of the above
- E. None of the above Discuss
Correct Answer: the difference between the control setpoint value and the actual value.
- 5. Ergonomics refers to:
Options- A. the human aspect of the environment around the workstation as well as the workstation itself
- B. the cost relationship of the workstation versus productivity
- C. the level of involvement the operator has with the workstation
- D. the technology involved in the workstation itself
- E. None of the above Discuss
Correct Answer: the human aspect of the environment around the workstation as well as the workstation itself
- 6. Which of the following is a graphical output device?
Options- A. Dot-matrix Printer
- B. Plotter
- C. Laser Printer
- D. Line Printer
- E. None of the above Discuss
Correct Answer: Plotter
- 7. In the operation of a programmable controller:
Options- A. all of the logic status is maintained in memory
- B. any latched data must be done using an external latching relay
- C. mathematics cannot be performed
- D. All of the above
- E. None of the above Discuss
Correct Answer: all of the logic status is maintained in memory
- 8. One advantage of a PC in industrial control is that it:
Options- A. has a reliable long life compared to relay logic
- B. is very difficult for the inexperienced programmer to understand
- C. is unreliable because there are no moving parts
- D. All of the above
- E. None of the above Discuss
Correct Answer: has a reliable long life compared to relay logic
- 9. The program execution time:
Options- A. must be slower than the fastest mechanical operation that is to be controlled
- B. will vary depending on the language used
- C. cannot be changed once the program is written
- D. All of the above
- E. None of the above Discuss
Correct Answer: will vary depending on the language used
- 10. Skipping every other line and picking up the skipped lines on the second pass is called:
Options- A. interlacing
- B. refresh-vector
- C. raster-scan
- D. stroke writing
- E. None of the above Discuss
Correct Answer: interlacing
More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.