Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
While the fuel fired furnace can be used upto a maximum temperature of about 1700°C, the electric furnace can be used upto a temperature of about __________ °C.
Options- A. 2000
- B. 3000
- C. 4500
- D. 6000
- Correct Answer
- 4500
- 1. Which of the following is not a recuperative furnace?
Options- A. Soaking pit
- B. Reheating furnace
- C. Steamboiler
- D. Coke oven. Discuss
- 2. Fuel economy in furnaces can be achieved by
Options- A. using oxygen enriched combustion air.
- B. preheating the combustion air.
- C. reducing the heat loss through furnace openings & doors.
- D. all (a), (b) and (c). Discuss
- 3. Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace?
Options- A. Increase in calorific value of the fuel.
- B. Increase in flame temperature.
- C. Reduction in scale losses.
- D. Saving in fuel consumption. Discuss
- 4. Rate of heat release in a furnace, which is the measure of heat intensity is defined as
Options- A. kcal/hr/m3 combustion space.
- B. kcal/m3 combustion space.
- C. kcal/hr.
- D. none of these. Discuss
- 5. Oxygen enrichment of combustion air does not result in increase of the
Options- A. flame temperature.
- B. oxygen in the flue gas.
- C. stack loss.
- D. heat transfer rate in the furnace. Discuss
- 6. Which is not accomplished in an underfired furnace?
Options- A. Increase in heating capacity/m2 of floor space.
- B. Elimination of cold spot at the bottom of the charge.
- C. Reduction in the temperature of furnace gases.
- D. Portection of the periphery of the charge from excessive radiation. Discuss
- 7. Main gas valve in a gaseous fuel burner is a __________ valve.
Options- A. gate
- B. butterfly
- C. globe
- D. none of these Discuss
- 8. Overfire burning in a furnace is a phenomenon characterised by
Options- A. supply of excess fuel.
- B. supply of excess air.
- C. burning carbon monoxide and other incombustible in upper zone of furnace by supplying more air.
- D. none of these. Discuss
- 9. An improved and fuel efficient version of the pusher type reheating furnace is the __________ furnace.
Options- A. walking beam
- B. shaft
- C. tunnel
- D. rotary hearth Discuss
- 10. Recuperator is
Options- A. not used for fuel gas preheating.
- B. an intermittant waste heat recovery equipment.
- C. a continuous waste heat recovery equipment.
- D. heavier than regenerator meant for the same duty. Discuss
Furnace Technology problems
Search Results
Correct Answer: Coke oven.
Correct Answer: all (a), (b) and (c).
Correct Answer: Increase in calorific value of the fuel.
Correct Answer: kcal/hr/m3 combustion space.
Correct Answer: oxygen in the flue gas.
Correct Answer: Increase in heating capacity/m2 of floor space.
Correct Answer: gate
Correct Answer: burning carbon monoxide and other incombustible in upper zone of furnace by supplying more air.
Correct Answer: walking beam
Correct Answer: a continuous waste heat recovery equipment.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.