Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Unit of furnace loading is
Options- A. ton stock/hr/m2 hearth area
- B. ton stock/hr
- C. ton stock/m2 hearth area
- D. both (b) and (c)
- Correct Answer
- ton stock/hr/m2 hearth area
- 1. In practical operation of any furnace, zero oxygen percentage or theoretical CO2 percentage in flue gas is rarely achieved, because of
Options- A. use of non-preheated combustion air.
- B. use of pulverised solid fuels.
- C. imperfect mixing of fuel & air and infiltration of air.
- D. use of excessive positive draft in the furnace. Discuss
- 2. Circulation of gases in furnace is caused by the
Options- A. change in volume during a change of temperature.
- B. difference in density between hot and cold gases.
- C. furnace pressure in conjunction with draft in flues.
- D. all (a), (b) and (c). Discuss
- 3. Which furnace employs an I.D. fan for the removal of flue gases from the furnace?
Options- A. Coke oven.
- B. Blast furnace stoves.
- C. Beehive coke oven.
- D. High pressure boiler. Discuss
- 4. An example of recuperative furnace is the
Options- A. soaking pit
- B. open hearth furnace
- C. coke ovens
- D. none of these Discuss
- 5. Neutral atmosphere is maintained in a/an __________ furnace.
Options- A. cold rolled steel coil annealing
- B. open hearth
- C. soaking pit
- D. walking beam reheating Discuss
- 6. The function of an economiser in a boiler is to preheat the
Options- A. feedwater
- B. combustion air
- C. pulverised coal
- D. furnace oil Discuss
- 7. Blast furnace stoves are meant for heating
Options- A. air
- B. blast furnace gas
- C. steam
- D. none of these Discuss
- 8. Oxygen enrichment of combustion air does not result in increase of the
Options- A. flame temperature.
- B. oxygen in the flue gas.
- C. stack loss.
- D. heat transfer rate in the furnace. Discuss
- 9. Rate of heat release in a furnace, which is the measure of heat intensity is defined as
Options- A. kcal/hr/m3 combustion space.
- B. kcal/m3 combustion space.
- C. kcal/hr.
- D. none of these. Discuss
- 10. Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace?
Options- A. Increase in calorific value of the fuel.
- B. Increase in flame temperature.
- C. Reduction in scale losses.
- D. Saving in fuel consumption. Discuss
Furnace Technology problems
Search Results
Correct Answer: imperfect mixing of fuel & air and infiltration of air.
Correct Answer: all (a), (b) and (c).
Correct Answer: High pressure boiler.
Correct Answer: soaking pit
Correct Answer: cold rolled steel coil annealing
Correct Answer: feedwater
Correct Answer: air
Correct Answer: oxygen in the flue gas.
Correct Answer: kcal/hr/m3 combustion space.
Correct Answer: Increase in calorific value of the fuel.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.