Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Reverberatory furnace is used for
Options- A. roasting/reduction of ores
- B. annealing steel coil
- C. heating air
- D. steel melting
- Correct Answer
- roasting/reduction of ores
- 1. Dampers are located
Options- A. before the I.D fan
- B. after the I.D. fan
- C. near the top of the chimney
- D. anywhere after the I.D. fan Discuss
- 2. Regenerators are used for waste heat recovery in
Options- A. by-product coke ovens
- B. beehive coke oven
- C. blast furnace stoves
- D. soaking pits Discuss
- 3. Turndown ratio of a burner gives an idea of the __________ in the furnace.
Options- A. range of fuel firing rates
- B. volume of the combustion chamber
- C. maximum heat input rate only
- D. minimum heat input rate only Discuss
- 4. Which furnace employs natural draft?
Options- A. Coke oven
- B. Boiler
- C. Rotary kilns
- D. L.D. converter Discuss
- 5. In a heating process, a heat flow diagram in which the quantities of heat in the various items of a heat balance are represented by the width of a band is called the
Options- A. Ostwald chart
- B. Cox chart
- C. Sankey diagram
- D. none of these Discuss
- 6. Protective gas used in the annealing furnace for steel coil comprises of
Options- A. 95% N2 + 5% H2
- B. 5% H2 + 9% N2
- C. 100% CO
- D. 100 %H2 Discuss
- 7. Reducing atmosphere is maintained in a
Options- A. calcination kiln
- B. blast furnace
- C. soaking pit
- D. L.D. converter Discuss
- 8. Which one shows the diagramatic heat balance in a furnace?
Options- A. Sankey diagram
- B. Cox chart
- C. Ostwald chart
- D. None of these Discuss
- 9. Artificial draught produced by a fan in the furnace can be controlled by the
Options- A. speed of the fan.
- B. damper.
- C. variation in the pitch of fan blades.
- D. all (a), (b) and (c). Discuss
- 10. Size of the combustion chamber of a furnace depends upon the
Options- A. heat release rate of the fuel.
- B. preheat temperature of fuel & air.
- C. method of mixing the fuel & air.
- D. all (a), (b) and (c). Discuss
Furnace Technology problems
Search Results
Correct Answer: before the I.D fan
Correct Answer: by-product coke ovens
Correct Answer: range of fuel firing rates
Correct Answer: Coke oven
Correct Answer: Sankey diagram
Correct Answer: 95% N2 + 5% H2
Correct Answer: blast furnace
Correct Answer: Sankey diagram
Correct Answer: all (a), (b) and (c).
Correct Answer: all (a), (b) and (c).
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.