Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Furnace pressure is normally controlled by regulating the
Options- A. air pressure
- B. fuel gas pressure
- C. speed of I.D. fan
- D. damper
- Correct Answer
- damper
- 1. In furnaces operating at very high temperature (say) 1250°C, e.g. soaking pit), the maximum heat transfer takes place by
Options- A. conduction
- B. convection
- C. radiation
- D. can not be predicted. Discuss
- 2. Hearth furnaces are not used for
Options- A. roasting
- B. melting
- C. reheating
- D. none of these Discuss
- 3. Heat balance of furnace provides means of determining the
Options- A. thermal efficiency of the process.
- B. sources of heat losses.
- C. scope of reduction of heat losses.
- D. all (a), (b) and (c). Discuss
- 4. Overall thermal efficiency of a lumpy coal fired suitably designed heating furnace, if operated & maintained properly may be about __________ percent.
Options- A. 10-15
- B. 25-30
- C. 45-50
- D. 65-70 Discuss
- 5. Regenerators compared to the recuperators for the same duty
Options- A. occupy more space
- B. are less costly
- C. are of smaller size
- D. all (a), (b) and (c) Discuss
- 6. Which of the following is a periodic furnace?
Options- A. Tunnel kiln
- B. Rotary kiln
- C. Soaking pit
- D. Reheating furnace. Discuss
- 7. Which of the following is the most important deterrants to an extended use of pulverised coal in boiler firing?
Options- A. Ash disposal problem.
- B. Excessive fly ash discharge from the stack.
- C. Higher power consumption in its transportation.
- D. Erosion of induced draft fan blades. Discuss
- 8. An example of indirectly heated furnace is the
Options- A. soaking pit
- B. muffle furnace
- C. reheating furnace
- D. none of these Discuss
- 9. Forced recirculation of furnace gases is practised
Options- A. to increase heat transfer by convection.
- B. to ensure uniform temperature.
- C. in furnaces, operating below 750°C.
- D. all (a), (b) and (c). Discuss
- 10. Flue gas outlet temperature from the chimney of any furnace should be ideally about __________ °C.
Options- A. 50
- B. 100
- C. 150
- D. 250 Discuss
Furnace Technology problems
Search Results
Correct Answer: radiation
Correct Answer: none of these
Correct Answer: all (a), (b) and (c).
Correct Answer: 25-30
Correct Answer: occupy more space
Correct Answer: Soaking pit
Correct Answer: Ash disposal problem.
Correct Answer: muffle furnace
Correct Answer: all (a), (b) and (c).
Correct Answer: 150
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.